Toyota Venza: Problem Symptoms Table

Toyota Venza Service Manual / Theft Deterrent / Keyless Entry / Engine Immobiliser System(w/ Smart Key System) / Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses and relays related to this system before inspecting the suspected areas below.

Engine Immobiliser System

Symptom	Suspected Area	See page
Engine does not start.	Key
	Steering lock ECU power source circuit
	Smart key system (for start function)
	SFI system (for 2GR-FE)
	SFI system (for 1AR-FE)
Security indicator light is always on.	Certification ECU (smart key ECU assembly)
	Wire harness or connector	-
	Accessory meter assembly	-
Security indicator light is off.	Certification ECU (smart key ECU assembly)
	Wire harness or connector	-
	Accessory meter assembly	-

System Description

SYSTEM DESCRIPTION 1. ENGINE IMMOBILISER SYSTEM DESCRIPTION The immobiliser system is a theft deterrent system that determines whether to disable starting of the SFI system based on a comparison o ...

Registration

REGISTRATION PROCEDURE 1. DESCRIPTION OF CODE REGISTRATION HINT: The ID codes are the same as recognition codes for the wireless transmitter and the engine immobiliser function. Regist ...

Other materials about Toyota Venza:

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY NOTICE: The regulator arm mu ...

AWD Warning Light Remains ON
DESCRIPTION The AWD control ECU is connected to the combination meter via the CAN communication system. If the AWD control ECU stores any DTCs which are related to the active torque control 4WD system, the AWD warning light comes on in the combination me ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE TRANSMISSION WIRE 2. REMOVE ATF TEMPERATURE SENSOR ASSEMBLY (a) Remove the 4 bolts, ATF temperature sensor assembly and clamp from the valve body assembly. Text in Illustration *1 ...