PROBLEM SYMPTOMS TABLE
HINT:
Symptom |
Suspected Area |
See page |
---|---|---|
The SRS warning light goes off after the primary check, but then comes on. |
SRS Warning Light Remains ON |
|
With the ignition switch is turned ON, the SRS warning light sometimes comes on after approximately 6 seconds. |
SRS Warning Light Remains ON |
|
The SRS warning light always comes on even when DTC is not output. |
SRS Warning Light Remains ON |
|
With the ignition switch is turned ON, the SRS warning light does not come on. |
SRS Warning Light does not Come ON |
|
Although the SRS warning light operates normally, DTC or a normal system code is not displayed. |
TC and CG Terminal Circuit |
|
Although terminals TC and CG of DLC3 are not connected, a DTC or normal system code is displayed. |
TC and CG Terminal Circuit |
|
Open in CAN Main Bus Line
DESCRIPTION
There may be an open circuit in the CAN bus main wire and/or the DLC3 branch
wire when the resistance between terminals 6 (CANH) and 14 (CANL) of the DLC3 is
70 Ω or higher.
Symptom
Trouble Area
Resista ...
Installing child restraints using a seat belt (child restraint lock function
belt)
- Rear-facing -- Infant seat/convertible seat
Place the child restraint system on the rear seat facing the rear of the vehicle.
Run the seat belt through the child restraint system and insert the plate into
the buckle. Make sure that the belt is ...
System Description
SYSTEM DESCRIPTION
1. PUSH-BUTTON START DESCRIPTION
(a) The push-button start uses a push-type engine switch, which the driver can
operate by merely carrying the electrical key. This system consists primarily of
the power management control ECU, engine s ...