Toyota Venza: Problem Symptoms Table

Toyota Venza Service Manual / Seat Belt / Seat Belt Warning System / Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses and relays related to this system before inspecting the suspected areas below.

Seat Belt Warning System

Symptom	Suspected Area	See page
Driver Side Seat Belt Warning Light does not Operate	CAN communication system
	Airbag system	-
	Combination meter assembly	-
Front Passenger Seat Belt Warning Light does not Operate	CAN communication system
	Airbag system	-
	Occupant classification system	-
	Combination meter assembly	-
	Accessory meter assembly	-
	Wire harness or connector	-

Customize Parameters

CUSTOMIZE PARAMETERS 1. CUSTOMIZE FUNCTION WITH TECHSTREAM NOTICE: Be sure to record the current settings before customizing. These buzzers should be ON for safe driving. Perform these ...

Diagnosis System

DIAGNOSIS SYSTEM 1. CHECK DLC3 (a) Check the DLC3 (See page ). 2. INSPECT BATTERY VOLTAGE (a) Measure the battery voltage. Standard Voltage: 11 to 14 V If the voltage is below 11 V, recharge ...

Other materials about Toyota Venza:

Poor Sound Quality in All Modes (Low Volume)
PROCEDURE 1. CHECK AUDIO SETTINGS (a) Set treble, middle and bass to the initial values and check that the sound is normal. OK: The sound returns to normal. HINT: Sound quality adjustment measures vary according to the ...

Check Mode Procedure
CHECK MODE PROCEDURE 1. DESCRIPTION (a) Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect all the malfunctions that normal mode can detect. In check mode, DTCs are d ...

Installation
INSTALLATION PROCEDURE 1. CLEAN QUARTER WINDOW ASSEMBLY (a) Clean the outer edges of the quarter window assembly with a non-residue solvent. NOTICE: Do not touch the glass surface after cleaning it. Be careful not to ...