Toyota Venza: Problem Symptoms Table

Toyota Venza Service Manual / Meter / Gauge / Display / Clock System / Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

Clock

Symptom	Suspected Area	See page
Clock does not operate at all.	Fuse (ECU-B, GAUGE NO. 2)	-
	Wire Harness or Connector	-
	Clock (Accessory Meter Assembly (w/o Multi-information Display))
	Clock (Accessory Meter Assembly (w/ Multi-information Display))
Clock display illumination malfunction	PANEL Fuse	-
	Wire Harness or Connector	-
	Clock (Accessory Meter Assembly (w/o Multi-information Display))
	Clock (Accessory Meter Assembly (w/ Multi-information Display))
Clock loses or gains time.	Clock (Accessory Meter Assembly (w/o Multi-information Display))
Clock loses or gains time.	Clock (Accessory Meter Assembly (w/ Multi-information Display))

System Description

SYSTEM DESCRIPTION 1. ACCESSORY METER ASSEMBLY (a) Warning or Indicator Item Detail Front passenger side seat belt warning light Receives a front p ...

Combination Meter

Components COMPONENTS ILLUSTRATION Disassembly DISASSEMBLY PROCEDURE 1. REMOVE COMBINATION METER GLASS (a) Disengage the 9 claws to remove the combination meter glass. ...

Other materials about Toyota Venza:

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON and turn the Techstream on. (c) Enter the following menus: Body Electrical / Trouble Codes. (d) Check for DTCs. 2. CLEAR DTC (a) Connect the Techst ...

Noise Occurs from Generator while Engine is Running
PROCEDURE 1. CHECK LOOSENESS OF V-RIBBED BELT (a) Check the tension of the belt by pushing it down with a finger. OK: The tension of the belt is enough. NG ADJUST V-RIBBED BELT ...

Lost Communication with ECM / PCM "A" (U0100,U0129)
DESCRIPTION The power steering ECU receives signals from the ECM and the brake actuator assembly (skid control ECU) via the CAN communication system. DTC No. DTC Detection Condition Trouble Area U0100 ...