Toyota Venza: Problem Symptoms Table

Toyota Venza Service Manual / Door / Hatch / Back Door Closer System / Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses and relays related to this system before inspecting the suspected areas below.

Back Door Closer System

Symptom	Suspected Area	See page
Back Door cannot be Opened	Back door opener switch assembly
	Back door lock assembly	-
	Power back door ECU (Power back door motor unit)*1	-
	Back door closer ECU (Multiplex network door ECU)*2	-
	Main body ECU (Driver side junction block assembly)	-
	Wire harness or connector	-
Back Door Closer does not Operate	Back door lock assembly
	Power back door ECU (Power back door motor unit)*1	-
	Back door closer ECU (Multiplex network door ECU)*2	-
	Touch sensor circuit	-
	Wire harness or connector	-

*1: w/ Power Back Door System
*2: w/o Power Back Door System

Initialization

INITIALIZATION 1. RESET BACK DOOR CLOSE POSITION (w/ POWER BACK DOOR SYSTEM) NOTICE: Perform initialization of the power back door system (power back door ECU initialization) if one of the follow ...

Terminals Of Ecu

TERMINALS OF ECU 1. CHECK POWER BACK DOOR ECU (POWER BACK DOOR MOTOR UNIT) (w/ POWER BACK DOOR SYSTEM) (a) Disconnect the L20 power back door ECU connector. (b) Measure the voltage and resistan ...

Other materials about Toyota Venza:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT HOOD SUB-ASSEMBLY (a) Check that the clearance measurements of areas *1 through *4 are within each standard range. Standard Clearance Area Measurement Area Measureme ...

System Diagram
SYSTEM DIAGRAM 1. CAN SIGNAL 2. DIRECT LINE SIGNAL (a) Combination Meter Assembly (b) Accessory Meter Assembly 3. INPUT AND OUTPUT SIGNALS OF THE COMBINATION METER ASSEMBLY OR ACCESSORY METER ASSEMBLY (a) Meter or Gauge Meter or Gauge ...

Disassembly
DISASSEMBLY PROCEDURE 1. INSPECT FRONT OIL PUMP AND GEAR BODY SUB-ASSEMBLY 2. REMOVE STATOR SHAFT ASSEMBLY (a) Using a "TORX" wrench (T30), remove the 16 bolts and stator shaft assembly from the oil pump body. NOTICE: Keep ...