PROBLEM SYMPTOMS TABLE
HINT:
Symptom |
Suspected Area |
See page |
---|---|---|
Open in CAN Main Bus Line. |
CAN Main Bus Line |
|
Short in CAN Bus Lines. |
CAN Bus Lines |
|
Short to +B in CAN Bus Line. |
CAN Bus Line |
|
Short to GND in CAN Bus Line. |
CAN Bus Line |
|
Open in One Side of CAN Branch Line. |
CAN Branch Line |
|
HINT:
Refer to the How to Proceed with Troubleshooting for the CAN No. 1 Bus Check procedure.
Communication Stop Mode Table
Symptom |
Suspected Area |
See page |
---|---|---|
"ABS/VSC/TRAC" is not displayed on the Techstream. |
Skid Control ECU Communication Stop Mode |
|
"Air Conditioner" is not displayed on the Techstream. |
Air Conditioning Amplifier Communication Stop Mode |
|
"EPS" is not displayed on the Techstream. |
Power Steering ECU Communication Stop Mode |
|
"Steering Angle Sensor" is not displayed on the Techstream. |
Steering Angle Sensor Communication Stop Mode |
|
"Yaw Rate/Deceleration Sensor" is not displayed on the Techstream. |
Yaw Rate Sensor Communication Stop Mode |
|
"Engine" and/or "ECT" is not displayed on the Techstream. |
ECM Communication Stop Mode |
|
"Main Body" is not displayed on the Techstream. |
Main Body ECU Communication Stop Mode |
|
"Electric Power Control" is not displayed on the Techstream. |
Power Management Control ECU Communication Stop Mode |
|
"Combination Meter" is not displayed on the Techstream. |
Combination Meter ECU Communication Stop Mode |
|
"Smart Access/Smart Key/Wireless Tuner" is not displayed on the Techstream. |
Certification ECU Communication Stop Mode |
|
"SRS Airbag" is not displayed on the Techstream. |
Center Airbag Sensor Communication Stop Mode |
|
"Four Wheel Drive Control" is not displayed on the Techstream. |
4WD Control ECU Communication Stop Mode |
|
"Navigation System" is not displayed on the Techstream. |
Navigation Receiver Assembly Communication Stop Mode |
|
"Navigation System" is not displayed on the Techstream. |
Audio Receiver Assembly Communication Stop Mode |
|
Starter Relay Circuit High (P0617)
DESCRIPTION
While the engine is being cranked, battery voltage is applied to terminal STA
of the TCM.
If the TCM detects the Starter Control (STA) signal while the vehicle is being
driven, it determines that there is a malfunction in the STA circuit. The ...
Route cannot be Calculated
PROCEDURE
1.
SET DESTINATION
(a) Set another destination and check if the system can calculate the route correctly.
OK:
Route can be correctly calculated.
OK
END
NG
PROCEED T ...
Steering Pad Switch Circuit
DESCRIPTION
This circuit sends an operation signal from the steering pad switch assembly
to the navigation receiver assembly.
If there is an open in the circuit, the audio system cannot be operated using
the steering pad switch assembly.
If there is a s ...