PRECAUTION
1. INITIALIZATION
NOTICE:
Perform the Registration (VIN registration) when replacing the ECM (See page ).
HINT:
Reset memory or initialization cannot be completed by only disconnecting and reconnecting the cable of the negative (-) battery terminal.
2. FOR USING TECHSTREAM
CAUTION:
Observe the following items for safety reasons:
3. DISCONNECTING AND RECONNECTING NEGATIVE (-) BATTERY CABLE
(a) Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to electrical system or electrical components.
Text in Illustration
*1 |
Negative (-) Battery Terminal |
*2 |
Cable |
(b) Before disconnecting and reconnecting the battery cable, turn the ignition switch off and the headlight switch off. Then loosen the terminal nut completely. Do not damage the cable or terminal.
(c) When the battery cable is disconnected, the clock and radio settings and stored DTCs are cleared. Therefore, before disconnecting the battery cable, make a note of them.
NOTICE:
System Name |
See Procedure |
---|---|
Back Door Closer System |
|
Power Back Door System |
4. EXPRESSION OF IGNITION SWITCH
HINT:
The type of ignition switch used on this model differs according to the specifications of the vehicle.
The expressions listed in the table below are used in this section.
Expression |
Switch Type |
|
---|---|---|
Ignition Switch (Position) |
Engine Switch (Condition) |
|
Ignition switch off |
LOCK |
Off (Lock) |
Ignition switch ON |
ON |
On (IG) |
Ignition switch ACC |
ACC |
On (ACC) |
Engine start |
START |
On (Start) |
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL FRONT OIL PUMP OIL SEAL
(a) Using SST and a hammer, install a new oil seal to the oil pump body.
SST: 09350-32014
09351-32140
Oil seal driven in depth:
-0.25 to 0.25 mm (-0.00984 to 0.00984 in.)
...
Auxiliary boxes
►Type A (driver’s side instrument panel)
Push down the knob.
►Type B (front console)
Lift the lid.
►Type C (front console)
Lift the lid.
►Type D (front passenger’s side instrument
panel)
- Coin holder (type A) ...
Rear Power Window LH does not Operate with Rear Power Window Switch LH
DESCRIPTION
When the engine is running or the ignition switch is ON, the power window regulator
motor assembly (for rear LH side) is operated by the power window regulator switch
assembly (for rear LH side). The power window regulator motor has motor, reg ...