Toyota Venza manuals

Toyota Venza: Precaution

PRECAUTION

1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.

System Name

See Procedure

Back Door Closer System


Power Back Door System

2. PRECAUTIONS FOR INTUITIVE PARKING ASSIST SYSTEM

(a) Under the following conditions, the detection function may not function properly:

HINT:

  • In very cold weather where a malfunction display appears, the sensor may not be able to detect obstacles.
  • If the malfunction display appears, visually check the sensor first. If the sensor is free of foreign matter but the malfunction display remains, the sensor may have a malfunction.

(1) A sensor is covered with foreign matter, such as mud or snow (detection function returns to normal when the sensor is cleaned).

(2) A sensor is frozen (detection function returns to normal when the temperature of the sensor rises).

(3) A hand is blocking a sensor.

(b) The detection range may be affected by the following conditions:

(1) A sensor is covered with foreign matter, such as mud or snow.

(2) The vehicle is in an excessively hot or excessively cold area.

(c) Under the following conditions, a detection error may occur:

(1) Driving on a bumpy road, an unpaved road or in tall grass.

(2) Ultrasonic waves are received from the horn or parking sonar system of another vehicle, a motorcycle engine, or the air brakes of a large vehicle.

(3) It is raining heavily or the sensor is splashed with water.

(4) The vehicle is tilted at a steep angle.

(5) The vehicle is equipped with a fender pole or a wireless antenna mechanism.

(6) A sensor is covered with foreign matter, such as mud or snow.

(7) The vehicle is moving forward or backward towards high curbs or objects that are perpendicular to the ground.

(8) A sensor is sprayed with high pressure water or steam.

(9) A towing hitch is mounted on the vehicle.

(d) The sensors cannot detect the following objects:

(1) Thin objects, such as wires and ropes

(2) Materials that absorb ultrasonic waves, such as cotton, snow, etc.

(3) Objects with sharp edges

(4) Short objects

(5) Objects that are tall and protrude toward the vehicle above the detection range of the sensors

(e) Other notices:

(1) The sensors cannot detect objects directly under the bumper. (A sensor may detect low objects and thin poles, and then lose track of them.)

(2) Be aware that the detection range of this system is limited. In certain conditions, some objects may not be detected. As a result, always make sure to check all around the vehicle when driving or parking.

(3) The sensors may not be able to detect obstacles that are too close to the sensor.

(4) The sensors may not be able to detect obstacles if the sensors have been dropped or subjected to a strong impact.

Intuitive Parking Assist System
...

Parts Location
PARTS LOCATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Inspection
INSPECTION PROCEDURE 1. INSPECT TIE ROD ASSEMBLY LH (a) Secure the tie rod assembly LH in a vise. (b) Install the nut to the stud bolt. (c) Flip the ball joint back and forth 5 times. (d) Set a to ...

Inspection
INSPECTION PROCEDURE 1. INSPECT STARTER ASSEMBLY NOTICE: These tests must be performed within 3 to 5 seconds to avoid burning out the coil. (a) Perform a pull-in test. (1) Remove the nut and disconnect the lead wire from terminal C. (2) Con ...

Transfer Case Front Oil Seal(for Rh Side)
Components COMPONENTS ILLUSTRATION Replacement REPLACEMENT PROCEDURE 1. DRAIN TRANSFER OIL (a) Remove the transfer drain plug and gasket to drain the transfer oil. (b) Install a new gasket and the transfer drain plug. Torque: 49 N·m {500 kgf ...

© 2016-2024 Copyright www.tovenza.com

0.1606