Toyota Venza manuals

Toyota Venza: Precaution

PRECAUTION

1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

  • After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
  • When disconnecting the cable from the negative (-) battery terminal, initialize the following system after the terminal is reconnected.

    System Name

    See Procedure

    Back Door Closer System


    Power Back Door System

2. IGNITION SWITCH EXPRESSIONS

(a) The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression

Ignition Switch

(Position)

Engine Switch

(Condition)

Ignition Switch off

LOCK

Off (Lock)

Ignition Switch ACC

ACC

On (ACC)

Ignition Switch ON

ON

On (IG)

Engine Start

START

On (Start)

Parts Location
PARTS LOCATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

System Diagram
SYSTEM DIAGRAM ...

Other materials about Toyota Venza:

Security Indicator Light Circuit
DESCRIPTION The security indicator light blinks continuously due to a continuous signal received from the certification ECU (smart key ECU assembly) while the engine immobiliser is set. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: If the certifica ...

Installation
INSTALLATION PROCEDURE 1. INSTALL GENERATOR ASSEMBLY (a) Install the wire harness clamp with the bolt. Torque: 8.4 N·m {86 kgf·cm, 74 in·lbf} (b) Install the 2 bolts. Torque: ...

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) The transponder key ECU assembly controls the vehicle's immobiliser system functions. Immobiliser system data and Diagnostic Trouble Code (DTC) can be read through the vehicle's Data Link Connector 3 (DLC3). I ...

© 2016-2024 Copyright www.tovenza.com

0.1728