PRECAUTION
1. PRECAUTION FOR VEHICLE WITH SRS AIRBAG AND SEAT BELT PRETENSIONER
(a) Some operations in this section may affect the SRS airbags. Prior to performing the corresponding operations, read the precautions regarding the SRS airbags (See page ).
2. TABLE OF BOLT, SCREW AND NUT
HINT:
All bolts, screws and nuts relevant to installing and removing the instrument panel are shown along with their alphabet code in the table below.
Code |
Shape |
Size |
Code |
Shape |
Size |
---|---|---|---|---|---|
<A> |
φ = 8 mm (0.315 in.) Length = 20 mm (0.787 in.) |
<B> |
φ = 8 mm (0.315 in.) Length = 25 mm (0.984 in.) |
||
<C> |
φ = 6 mm (0.236 in.) Length = 18 mm (0.709 in.) |
<D> |
φ = 6 mm (0.236 in.) Length = 15 mm (0.591 in.) |
||
<E> |
φ = 5 mm (0.197 in.) Length = 16 mm (0.630 in.) |
<F> |
φ = 5 mm (0.197 in.) Length = 14 mm (0.551 in.) |
||
<G> |
φ = 6 mm (0.236 in.) |
<H> |
φ = 6 mm (0.236 in.) |
TC and CG Terminal Circuit
DESCRIPTION
DTC output mode is set by connecting terminals TC and CG of the DLC3.
DTCs are displayed by blinking of the SRS warning light.
HINT:
When each warning light stays blinking, a ground short in the wiring
of terminal TC of the DLC3 or ...
Camshaft Position Sensor Circuit Malfunction (P0340,P0342,P0343)
DESCRIPTION
The camshaft position sensor (G signal sensor) for the intake camshaft consists
of a magnet and MRE (Magneto Resistance Element).
The camshaft has a timing rotor for the camshaft position sensor. When the camshaft
rotates, changes occur in th ...
Height Control Sensor
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (for 2WD)
(a) Disconnect the connector.
(b) Remove the 3 nuts ...