PRECAUTION
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
System Name |
See Procedure |
---|---|
Back Door Closer System |
|
Power Back Door System |
1. PRECAUTION FOR KEY REMINDER WARNING SYSTEM
(a) For the inspection procedure of the key reminder warning system for models equipped with the smart key system, refer to the Smart Key System (See page ).
2. PRECAUTIONS WHEN USING TECHSTREAM
(a) When using the Techstream to troubleshoot: Connect the Techstream to the vehicle while the ignition switch is off, and turn a courtesy light switch on and off at 1.5-second intervals until communication between the Techstream and the vehicle begins.
(b) After all DTCs are cleared, check if the trouble occurs again 6 seconds after the ignition switch is turned to ON.
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure listed to troubleshoot the Active Torque
Control 4WD system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
If the sensor rotor needs to be replaced, replace it together with the
front drive shaft assembly.
...
Auto Up Operation does not Fully Close Power Window (Jam Protection Function
is Activated)
DESCRIPTION
If a door glass or a power window regulator motor assembly does not operate smoothly,
the jam protection function may be triggered automatically, resulting in the auto
up function being unable to fully close the window.
HINT:
This symptom ma ...