Toyota Venza: Precaution

Toyota Venza Service Manual / Wiper / Washer / Wiper And Washer System / Precaution

PRECAUTION

NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

System Name	See Procedure
Back Door Closer System
Power Back Door System

1. PRECAUTION OF WASHER NOZZLE ADJUSTMENT

(a) Do not clean or adjust the washer nozzle with a safety pin, etc. because:

(1) the washer nozzle tip is made of resin and could be damaged.

(2) adjustment is not necessary for this spray type washer nozzle. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle.

(b) If the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush or other cleaning tool.

Wiper And Washer System

...

How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the wiper and washer system. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP ...

Other materials about Toyota Venza:

Air Mix Damper Control Servo Motor Circuit (Driver Side) (B1446/46)
DESCRIPTION The air mix control servo motor sends pulse signals to indicate the damper position to the A/C amplifier. The A/C amplifier activates the motor (normal or reverse) based on these signals to move the air mix damper (driver side) to any position ...

Removal
REMOVAL PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing (See page ). If the front seat side airbag assembly was deployed, replace the front seat side airbag assembly, front seat frame assembly wit ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH side and RH side. The following procedure is for the LH side. If the sensor rotor needs to be replaced, replace it together with the rear drive shaft assembly. ...