PRECAUTION
1. EXPRESSIONS OF IGNITION SWITCH
(a) The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
Switch Type |
Ignition Switch (Position) |
Engine Switch (Condition) |
|
---|---|---|---|
Expression |
Ignition switch off |
LOCK |
Off |
Ignition switch ON |
ON |
On (IG) |
|
Ignition switch ACC |
ACC |
On (ACC) |
|
Engine Start |
START |
Start |
2. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected:
System Name |
See Procedure |
---|---|
Back Door Closer System |
|
Power Back Door System |
3. POWER WINDOW CONTROL SYSTEM PRECAUTIONS
CAUTION:
NOTICE:
Do not disconnect the battery while the ignition switch is ON. Otherwise, DTC B2311 will be output.
Freeze Frame Data
FREEZE FRAME DATA
1. DESCRIPTION
The ECM records vehicle and driving condition information as freeze
frame data the moment a DTC is stored. When troubleshooting, freeze frame
data can be helpful in determining whether the vehicle was moving or ...
Ultrasonic Sensor(for Front Side)
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT BUMPER ASSEMBLY
(See page )
2. REMOVE NO. 1 ULTRASONIC SENSOR
(a) Disengage the 2 claws to remove the No. 1 ultrasonic sensor.
HINT:
Use the same proc ...
Indicator Circuit
DESCRIPTION
The headlight beam level control system indicator light in the combination meter
assembly comes on for approximately 3 seconds when the ignition switch is turned
to ON. The indicator light also comes on when the headlight leveling ECU assembly ...