PRECAUTION
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
System Name |
See Procedure |
---|---|
Back Door Closer System |
|
Power Back Door System |
1. PRECAUTIONS WHEN USING TECHSTREAM
(a) When using the Techstream to troubleshoot with the ignition switch off:
Connect the Techstream to the DLC3, and turn the courtesy light switch on and off at 1.5-second intervals until communication between the Techstream and vehicle begins.
(b) After all DTCs are cleared, check if the trouble occurs again 6 seconds after the ignition switch is turned to ON.
2. PRECAUTIONS WHEN WORKING ON STEERING LOCK SYSTEM
(a) After replacing the steering lock ECU (steering lock actuator assembly), perform the key ID code registration.
(b) After replacing the steering lock ECU (steering lock actuator assembly), confirm the lock/unlock operation of the steering lock.
Operation Confirmation
Steering Lock Condition |
Operation Condition |
---|---|
Lock |
With the ignition switch off, open and close any door. |
Unlock |
Turn the ignition switch from off to ON or ACC. |
Steering Position Sensor Malfunction (B2414)
DESCRIPTION
The AFS ECU (headlight swivel ECU assembly) receives signals indicating the swerve-angle
from the steering angle sensor using CAN communication.
DTC No.
DTC Detection Condition
Trouble Area
B241 ...
Lost Communication with AFS LIN (B124D)
DESCRIPTION
Refer to DTC B124D (Lighting system) (See page
).
DTC No.
DTC Detection Condition
Trouble Area
B124D
Malfunctions in LIN communication system
Inner rear view mir ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Driver Seat / Trouble Codes.
(e) Check for DTCs (See page ).
2. CLEA ...