Toyota Venza: Power Window Control System
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- System Description
- Operation Check
- Customize Parameters
- Initialization
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Fail-safe Chart
- Diagnostic Trouble Code Chart
- Power Window Motor Malfunction (B2311)
- Power Window Switch Malfunction (B2312)
- Glass Position Initialization Incomplete (B2313)
- Remote Up / Down Function does not Operate
- Driver Side Power Window does not Operate with Power Window Master Switch
- Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch
- Rear Power Window LH does not Operate with Rear Power Window Switch LH
- Rear Power Window RH does not Operate with Rear Power Window Switch RH
- Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch
- Front Passenger Side Power Window Auto Up / Down Function does not Operate with Front Passenger Side Power Window Switch
- Rear Power Window LH Auto Up / Down Function does not Operate with Rear Power Window Switch LH
- Rear Power Window RH Auto Up / Down Function does not Operate with Rear Power Window Switch RH
- Key-off Operation Function Operates even if Operating Conditions are not Satisfied
- Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)
- Jam Protection Function does not Operate
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
The front side fix window assembly can be reused. When installing the
window, if any of the clips on the front side fix window assembly are broken, ...
Precaution
PRECAUTION
1. EXPRESSIONS OF IGNITION SWITCH
(a) The type of ignition switch used on this model differs according to the specifications
of the vehicle. The expressions listed in the table below ar ...
Other materials about Toyota Venza:
Vehicle Lift And Support Locations
VEHICLE LIFT AND SUPPORT LOCATIONS
1. NOTICE ABOUT VEHICLE CONDITION WHEN RAISING VEHICLE
(a) The vehicle must be unloaded before jacking up or raising the vehicle. Never
jack up or raise a heavily loaded vehicle.
(b) When removing any heavy components li ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
(a) Align the splines of the shaft and install the drive shaft assembly
LH using a brass bar and a hammer.
NOTICE:
Set the shaft snap ring with the opening fac ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT CYLINDER BLOCK FOR WARPAGE
(a) Using a precision straightedge and feeler gauge, check the surface
that is in contact with the cylinder head gasket for warpage.
Maximum Warpage:
0.05 mm (0.00197 in.)
I ...
0.1491