DESCRIPTION
When the engine switch is pushed with the electrical key in the cabin, the power management control ECU receives signals to change the power source mode.
HINT:
To allow use of the Techstream to inspect the push-button start function when the power source mode is off, repeat opening and closing any of the doors. Opening and closing a door establishes communication between the Techstream and the power management control ECU. (Opening and closing a door can also be simulated by operating a door courtesy light switch.)
WIRING DIAGRAM
Refer to DTC B2274 (See page ).
PROCEDURE
1. |
CHECK HARNESS AND CONNECTOR (BATTERY - POWER MANAGEMENT CONTROL ECU) |
See page
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR (BATTERY - POWER MANAGEMENT CONTROL ECU) |
|
2. |
CHECK HARNESS AND CONNECTOR |
See page
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
3. |
INSPECT ACC RELAY |
See page
NG |
REPLACE ACC RELAY |
|
4. |
CHECK HARNESS AND CONNECTOR |
See page
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
5. |
CHECK HARNESS AND CONNECTOR |
See page
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
6. |
CHECK POWER MANAGEMENT CONTROL ECU |
(a) Reconnect the all connectors. |
|
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
D43-19 (ACCD) - Body ground |
Engine switch off |
Below 1 V |
D43-19 (ACCD) - Body ground |
Engine switch on (IG) |
Output voltage at terminal AM21 or AM22 -2 V or more |
*1 |
Components with harness connected (Power Management Control ECU) |
OK |
REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY) |
NG |
REPLACE POWER MANAGEMENT CONTROL ECU |
Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component
Amplifier
DESCRIPTION
This circuit sends a signal to the stereo component amplifier assembly to mute
noise. Due to this, the noise produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when
changing ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE PROPELLER SHAFT
(a) Place matchmarks on both flanges.
Text in Illustration
*1
Matchmark
(b) Remove the 4 nuts, ...
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...