Toyota Venza: Power Outlets (int)

Installation

INSTALLATION PROCEDURE 1. INSTALL INNER REAR VIEW MIRROR ASSEMBLY (w/o Automatic High Beam System) (a) Using a T20 "TORX" socket wrench, install the inner rear view mirror assembly with ...

Center Power Outlet Socket

Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL CENTER POWER OUTLET SOCKET COVER (a) Engage the 2 claws to install the center power outlet soc ...

Other materials about Toyota Venza:

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE FUEL SENDER GAUGE 2. SEPARATE FUEL SUCTION PLATE SUB-ASSEMBLY (a) Disconnect the fuel pump connector from the fuel suction plate. NOTICE: Do not damage the wire harness. ...

Removal
REMOVAL PROCEDURE 1. REMOVE BACK DOOR PANEL TRIM ASSEMBLY 2. REMOVE REAR WIPER ARM HEAD CAP (a) Disengage the 4 claws and remove the rear wiper arm head cap as shown in the illustration. 3. ...

Washer Nozzle(for Rear Side)
Components COMPONENTS ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT REAR WASHER NOZZLE (a) With the engine running, check where the washer fluid hits the windshield. Standard Measurement Area ...