Toyota Venza: Power Back Door Touch Sensor

Toyota Venza Service Manual / Door / Hatch / Power Back Door Touch Sensor

Components

COMPONENTS

ILLUSTRATION

Removal

REMOVAL

PROCEDURE

1. REMOVE UPPER BACK WINDOW PANEL TRIM

2. REMOVE BACK DOOR PANEL TRIM ASSEMBLY

3. DISCONNECT POWER BACK DOOR ROD (for LH Side)

4. REMOVE BACK DOOR TRIM COVER

5. REMOVE POWER BACK DOOR TOUCH SENSOR ASSEMBLY

(a) Disconnect the connector.

(b) Remove the 5 bolts.

(d) Tie a string to the wire near the connector of the power back door touch sensor assembly.

(e) Remove the power back door touch sensor assembly.

HINT:

Leave the string inside the back door frame because it will be used for installation.

(f) Untie the string from the power back door touch sensor assembly.

Inspection

INSPECTION

PROCEDURE

1. INSPECT POWER BACK DOOR TOUCH SENSOR LH

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
1 (OSL) - 2 (OSLE)	Not pressed	950 to 1050 Ω
1 (OSL) - 2 (OSLE)	Pressed	Below 100 Ω

If the result is not as specified, replace the sensor.

2. INSPECT POWER BACK DOOR TOUCH SENSOR RH

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
1 (OSR) - 2 (OSRE)	Not pressed	950 to 1050 Ω
1 (OSR) - 2 (OSRE)	Pressed	Below 100 Ω

If the result is not as specified, replace the sensor.

Installation

INSTALLATION

PROCEDURE

1. INSTALL POWER BACK DOOR TOUCH SENSOR ASSEMBLY

(a) Tie the string to the wire near the connector of the power back door touch sensor assembly.

HINT:

Use the string that was left in the door during removal of the touch sensor assembly.

(b) Pull the string to help pass the connector through the inside of the back door frame.

(d) Install the power back door touch sensor assembly with the 5 bolts.

(e) Connect the connector.

2. INSTALL BACK DOOR TRIM COVER

3. CONNECT POWER BACK DOOR ROD (for LH Side)

4. INSTALL BACK DOOR PANEL TRIM ASSEMBLY

5. INSTALL UPPER BACK WINDOW PANEL TRIM

Touch Sensor Circuit

DESCRIPTION When the power back door ECU receives a jam signal from the touch sensor while the power back door is operating, the ECU reverses the back door operation and opens the door. WIRING D ...

Power Back Door Warning Buzzer

Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT POWER BACK DOOR WARNING BUZZER (a) Measure the resistance according to the value(s) in the table b ...

Other materials about Toyota Venza:

Blind Spot Mirrors
The Blind Spot Mirrors increase the view of surrounding area to assist the driver when checking surrounding area before changing lanes. 1. Blind Spot Mirror field of view 2. Main mirror field of view - Mirror angle can be adjusted when ►V ...

Voice is not Recognized
PROCEDURE 1. CHECK CONDITION (a) Check if the system voice recognition level is low when recognizing a particular voice. Result Proceed to System voice recognition level is low with an ...

Replacement
REPLACEMENT PROCEDURE 1. REPLACE GENERATOR DRIVE END FRAME BEARING (a) Remove the 4 screws and bearing retainer from the drive end frame. (b) Using SST and a hammer, tap out the drive end ...