Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT POWER BACK DOOR MAIN SWITCH
(a) Check that the switch function.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
6 (E) - 9 (UL) |
Free |
Below 1 Ω |
6 (E) - 9 (UL) |
Pushed |
10 kΩ or higher |
If the result is not as specified, replace the switch.
(b) Check that the switch illuminates.
(1) Apply battery voltage to the power back door main switch and check that the switch illuminates.
OK:
Measurement Condition |
Specified Condition |
---|---|
Battery positive (+) → 8 (ILL+) Battery negative (-) → 7 (ILL-) |
Illuminates |
If the result is not as specified, replace the switch.
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT DOOR SCUFF PLATE LH
2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
3. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
4. REMOVE POWER BACK DOOR MAIN SWITCH
(a) Disengage the 2 claws and remove the power back door main switch. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL POWER BACK DOOR MAIN SWITCH
(a) Engage the 2 claws and install the power back door main switch. |
|
2. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
3. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
4. INSTALL FRONT DOOR SCUFF PLATE LH
Dtc Check / Clear
DTC CHECK / CLEAR
NOTICE:
When the diagnosis system is changed from normal mode to check mode or vice versa,
all DTCs and freeze frame data recorded in normal mode are cleared. Before changing
modes, always check and make a note of DTCs and freeze frame ...
System Description
SYSTEM DESCRIPTION
1. POWER MIRROR CONTROL SYSTEM DESCRIPTION
(a) This system has the following functions: power retract mirror function*,
reverse shift-linked function, electrical remote control function, memory function
and mirror heater function.
...
Child restraint systems with a top tether strap
Secure the child restraint using
a seat belt or lower anchors, and do the following.
► Outside
Adjust the head restraint to the upmost position.
► Center
Lower the head restraint to the lowest position.
Open the anchor bracket cover, ...