Toyota Venza: Power Back Door Control Switch

Toyota Venza Service Manual / Door / Hatch / Power Back Door Control Switch

Components

COMPONENTS

ILLUSTRATION

Inspection

INSPECTION

PROCEDURE

1. INSPECT POWER BACK DOOR OPENER / CLOSER SWITCH

(a) Measure the resistance of the switch.

Standard resistance:

Tester Connection	Condition	Specified Condition
1(E) - 4(CSW)	Pushed (ON)	Below 1 Ω
1(E) - 4(CSW)	Free (OFF)	10 kΩ or higher

If the result is not as specified, replace the switch.

(b) Check that the switch illuminates.

Standard resistance:

Measurement Condition	Specified Condition
Battery positive (+) → 3 (ILL+) Battery negative (-) → 2 (ILL-)	Illuminates

Measurement Condition

Specified Condition

Battery positive (+) → 3 (ILL+)

Battery negative (-) → 2 (ILL-)

Illuminates

If the result is not as specified, replace the switch.

Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT DOOR SCUFF PLATE LH

2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

3. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

4. REMOVE BACK DOOR CONTROL SWITCH

(a) Disengage the 2 claws and remove the back door control switch.

Installation

INSTALLATION

PROCEDURE

1. INSTALL BACK DOOR CONTROL SWITCH

(a) Engage the 2 claws to install the back door control switch.

2. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

3. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH

4. INSTALL FRONT DOOR SCUFF PLATE LH

Power Back Door Closer Switch

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE BACK DOOR PANEL TRIM ASSEMBLY 2. REMOVE POWER BACK DOOR CLOSER SWITCH ASSEMBLY (a) Disconnect the con ...

Other materials about Toyota Venza:

Wireless Door Lock Tuner Circuit Malfunction (B1242)
DESCRIPTION The door control receiver receives signals from the transmitter and sends these signals to the main body ECU (driver side junction block assembly). DTC No. DTC Detection Condition Trouble Area B ...

AWD Warning Light does not Come ON
DESCRIPTION Refer to "AWD Warning Light Remains ON" (See page ). WIRING DIAGRAM Refer to "AWD Warning Light Remains ON" (See page ). CAUTION / NOTICE / HINT Check the condition of each related circuit connector before troubleshooti ...

Intuitive parking assist
The distance from your vehicle to nearby obstacles when parallel parking or maneuvering into a garage is measured by the sensors and communicated via the multi-information display and a buzzer. Always check the surrounding area when using this system. &n ...

Toyota Venza: Power Back Door Control Switch

Power Back Door Closer Switch

Power Back Door Drive Unit

Other materials about Toyota Venza: