Toyota Venza: Power Assist Systems
- Power Steering Ecu
- Power Steering System
- Parts Location
- Precaution
- System Diagram
- How To Proceed With Troubleshooting
- System Description
- Calibration
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Freeze Frame Data
- Data List / Active Test
- Fail-safe Chart
- Diagnostic Trouble Code Chart
- On-vehicle Inspection
- Lost Communication with ECM / PCM "A" (U0100,U0129)
- Assist Map Number Mismatch (C1582)
- PIG Power Supply Voltage Malfunction (C1552)
- Assist Map Number Un-Writing (C1581)
- IG Power Supply Voltage Malfunction (C1551)
- Motor Rotation Angle Sensor Malfunction (C1528)
- Vehicle Speed Signal Malfunction (C1541)
- Motor Circuit Malfunction (C1522-C1555)
- Torque Sensor Zero Point Adjustment Incomplete (C1516,C1526)
- Motor Circuit Malfunction (C1521,C1531-C1534,C1554)
- Torque Sensor Circuit Malfunction (C1511-C1514,C1517)
- Torque Sensor Zero Point Adjustment Undone (C1515,C1525)
- PS Warning Light Remains ON
Power Management Control Ecu
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT DOOR SCUFF PLATE RH
2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
3. REMOVE NO. 2 INSTRUMENT PANEL UNDER COV ...
Other materials about Toyota Venza:
Power Back Door cannot be Operated Using Any Switch
DESCRIPTION
When the power back door cannot be operated using any switch, one of the following
may be the cause: 1) initialization of the power back door ECU (power back door
motor unit), 2) power back door touch sensor circuit, 3) power back door main sw ...
Removal
REMOVAL
PROCEDURE
1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
See page for 2GR-FE
See page for 1AR-FE
2. REMOVE FRONT NO. 1 STABILIZER BRACKET LH
3. REMOVE FRONT NO. 1 STABILIZER BRACKET RH
HINT:
Perform the same procedure as for the LH side.
4. REM ...
Terminals Of Ecu
TERMINALS OF ECU
1. CENTER AIRBAG SENSOR ASSEMBLY
Terminal No.
Terminal Symbol
Destination
L31-1
SFL+
Front seat side airbag assembly LH (Side squib LH)
L31-2
...
0.1499