DESCRIPTION
This DTC is output when the sliding roof ECU (sliding roof drive gear sub-assembly) has not been initialized.
DTC Code |
DTC Detection Condition |
Trouble Area |
---|---|---|
B2343 |
Sliding roof ECU (sliding roof drive gear sub-assembly) has not been initialized. |
Sliding roof ECU (Sliding roof drive gear sub-assembly) |
WIRING DIAGRAM
Refer to DTC B2341 (See page ).
CAUTION / NOTICE / HINT
NOTICE:
PROCEDURE
1. |
INITIALIZE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) |
(a) Check that the sliding roof ECU (sliding roof drive gear sub-assembly) can be initialized (See page ).
OK:
Sliding roof ECU (sliding roof drive gear assembly) can be initialized.
NG |
REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) |
|
2. |
CHECK SLIDING ROOF OPERATION |
(a) Check the sliding roof auto operation (See page ).
OK:
Auto operation operates normally.
NG |
REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) |
|
3. |
CHECK DTC OUTPUT |
(a) Clear the DTC (See page ).
(b) Recheck for DTCs.
OK:
DTC B2343 is not output.
OK |
END |
NG |
REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) |
Ambient Temperature Sensor Circuit (B1412/12)
DESCRIPTION
The ambient temperature sensor is installed in front of the condenser. It detects
the ambient temperature to control air conditioning AUTO mode. This sensor is connected
to the A/C amplifier and detects fluctuations in the ambient temperature. ...
Front Left Sensor Malfunction (C1AE1)
DESCRIPTION
The No. 1 ultrasonic sensor (front left sensor) is installed on the front bumper.
The ECU detects obstacles based on signals received from the No. 1 ultrasonic sensor
(front left sensor). If the No. 1 ultrasonic sensor (front left sensor) has ...
Washer Nozzle(for Rear Side)
Components
COMPONENTS
ILLUSTRATION
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT REAR WASHER NOZZLE
(a) With the engine running, check where the washer fluid hits the windshield.
Standard Measurement
Area
...