Toyota Venza: Portable Player cannot be Connected Manually/Automatically

Toyota Venza Service Manual / Navigation / Multi Info Display / Navigation System / Portable Player cannot be Connected Manually/Automatically

CAUTION / NOTICE / HINT

HINT:

Some versions of "Bluetooth" compatible audio players may not function properly, or the functions may be limited using the navigation receiver assembly, even if the portable audio player itself can play files (See page ).

PROCEDURE

1.	CHECK CONNECTED DEVICE SETTINGS

(a) Check if the portable player is registered as a connected device.

NOTICE:

If a cellular phone is used as a portable player, it must be registered independently from the registration that is performed for the hands-free system.

HINT:

Only 5 portable players can be registered.

Result	Proceed to
The portable player is registered as a connected device.	A
The portable player is not registered as a connected device.	B

2.	CHECK SYMPTOMS

(a) Check the connection condition between the portable player and navigation receiver assembly.

The portable player cannot be connected under any of the following conditions:

The portable player is connected to another device.
The portable player is connected to the navigation receiver assembly using the hands-free function.
The navigation receiver assembly has cleared the portable player registration.
The portable player is off.

Result	Proceed to
The portable player cannot be connected automatically.	A
The portable player cannot be connected manually.	B

GO TO STEP 4

3.	CHECK AUTOMATIC CONNECTION SETTINGS

(a) Check the automatic connection settings of the "Bluetooth" audio.

(1) Check that the "Bluetooth" connection is on.

OK:

"Bluetooth" connection is on.

TURN "Bluetooth" POWER TO ON

4.	CHECK PORTABLE PLAYER STATUS

(a) Check the status of the portable player.

(1) Check that the portable player is not in standby mode.

(2) Check that the portable player is not connected to another device (headphones, etc.).

OK:

The portable player is not in standby mode and not connected to another device (headphones, etc.).

TAKE PORTABLE PLAYER OUT OF STANDBY MODE AND DISCONNECT OTHER DEVICES (HEADPHONES, etc.)

5.	CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL

(a) Check if the portable player can be connected manually/automatically to another "Bluetooth" audio compatible vehicle of the same model.

OK:

The portable player can be connected manually/automatically.

PORTABLE PLAYER IS NOT COMPATIBLE

6.	REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES

(a) Remove additional devices which use radio waves.

(b) Check if the portable player can be connected manually/automatically.

OK:

The portable player can be connected manually/automatically.

END

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Noise Occurs or Sound Skips when Portable Player Plays

CAUTION / NOTICE / HINT HINT: Perform this check with the portable player volume set at an appropriate level. Make sure that there are no obstructions between the portable player ...

Registered Device cannot be Deleted

PROCEDURE 1. DELETE OPERATION (a) Check if a registered portable player can be deleted normally. OK: Registered portable player can be deleted normally. OK ...

Other materials about Toyota Venza:

Front Stabilizer Bar(when Not Using The Engine Support Bridge For Awd)
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT FRONT STABILIZER LINK ASSEMBLY (a) Inspect the turning torque of the ball joint. (1) Secure the front stabilizer link assembly in a vise using aluminum ...

Rear Occupant Classification Sensor RH Circuit Malfunction (B1783)
DESCRIPTION The rear occupant classification sensor RH circuit consists of the occupant classification ECU and rear occupant classification sensor RH. DTC B1783 is recorded when a malfunction is detected in the rear occupant classification sensor RH circ ...

Microphone Circuit between Microphone and Navigation Receiver Assembly
DESCRIPTION The navigation receiver assembly and inner rear view mirror assembly (amplifier microphone assembly) are connected to each other using the microphone connection detection signal lines. Using this circuit, the navigation receiver ...