Toyota Venza: Portable Player cannot be Connected Manually/Automatically

Toyota Venza Service Manual / Audio / Video / Audio And Visual System / Portable Player cannot be Connected Manually/Automatically

CAUTION / NOTICE / HINT

HINT:

Some versions of "Bluetooth" compatible audio players may not function properly, or the functions may be limited using the radio and display receiver assembly, even if the portable audio player itself can play files (See page ).

PROCEDURE

1.	CHECK CONNECTED DEVICE SETTINGS

(a) Check if the portable player is registered as a connected device.

NOTICE:

If a cellular phone is used as a portable player, it must be registered independently from the registration that is performed for the hands-free system.

HINT:

Only 5 portable players can be registered.

Result	Proceed to
The portable player is registered as a connected device.	A
The portable player is not registered as a connected device.	B

2.	CHECK SYMPTOMS

(a) Check the connection condition between the portable player and the radio and display receiver assembly.

The portable player cannot be connected under any of the following conditions:

The portable player is connected to another device.
The portable player is connected to the radio and display receiver assembly using the hands-free function.
The radio and display receiver assembly has cleared the portable player registration.
The portable player is off.

Result	Proceed to
The portable player cannot be connected automatically.	A
The portable player cannot be connected manually.	B

GO TO STEP 4

3.	CHECK AUTOMATIC CONNECTION SETTINGS

(a) Check the automatic connection settings of the "Bluetooth" audio.

(1) Check that the "Bluetooth" connection is on.

OK:

"Bluetooth" connection is on.

TURN "Bluetooth" POWER TO ON

4.	CHECK PORTABLE PLAYER STATUS

(a) Check the status of the portable player.

(1) Check that the portable player is not in standby mode.

(2) Check that the portable player is not connected to another device (headphones, etc.).

OK:

The portable player is not in standby mode and not connected to another device (headphones, etc.).

TAKE PORTABLE PLAYER OUT OF STANDBY MODE AND DISCONNECT OTHER DEVICES (HEADPHONES, etc.)

5.	CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL

(a) Check if the portable player can be connected manually/automatically to another "Bluetooth" audio compatible vehicle of the same model.

OK:

The portable player can be connected manually/automatically.

PORTABLE PLAYER IS NOT COMPATIBLE

6.	REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES

(a) Remove additional devices which use radio waves.

(b) Check if the portable player can be connected manually/automatically.

OK:

The portable player can be connected manually/automatically.

END

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Noise Occurs or Sound Skips when Portable Player Plays

CAUTION / NOTICE / HINT HINT: Perform this check with the portable player volume set at an appropriate level. Make sure that there are no obstructions between the portable player ...

Registered Device cannot be Deleted

PROCEDURE 1. DELETE OPERATION (a) Check if a registered portable player can be deleted normally. OK: Registered portable player can be deleted normally. OK ...

Other materials about Toyota Venza:

Inspection
INSPECTION PROCEDURE 1. INSPECT FUEL PUMP ASSEMBLY WITH FILTER (a) Inspect fuel pump resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition ...

Engine Coolant Temperature / Intake Air Temperature Correlation (P011B)
DESCRIPTION The engine has two temperature sensors, an engine coolant temperature sensor and an intake air temperature sensor, to detect the temperature while the engine is in operation. A thermistor, whose resistance value varies according to the tempera ...

Lost Communication with ECM / PCM "A" (U0100)
DESCRIPTION The power management control ECU receives shift position information from 2 sources. It receives a shift position P signal from the shift lock control unit assembly via a direct line, and shift position information from the ECM via CAN. If the ...