Toyota Venza: Poor Sound Quality in All Modes (Low Volume)

Toyota Venza Service Manual / Audio / Video / Audio And Visual System / Poor Sound Quality in All Modes (Low Volume)

PROCEDURE

1.	CHECK AUDIO SETTINGS

(a) Set treble, middle and bass to the initial values and check that the sound is normal.

OK:

The sound returns to normal.

HINT:

Sound quality adjustment measures vary according to the type of amplifier.

END

2.	COMPARE WITH ANOTHER VEHICLE OF SAME MODEL

(a) Compare with another vehicle of the same model which is not malfunctioning to see if there is any difference in the sound quality.

OK:

No difference is found.

END

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Screen Flicker or Color Distortion

PROCEDURE 1. CHECK DISPLAY SETTING (a) Reset display settings (contrast, brightness) and check that the screen appears normal. OK: The display returns to normal. ...

Voice Guidance does not Function

PROCEDURE 1. CHECK VOICE GUIDANCE SETTING (a) Check that the voice guidance setting is not off. OK: Voice guidance setting is not off. NG CHANG ...

Other materials about Toyota Venza:

LIN Communication Master Malfunction (B2287)
DESCRIPTION This DTC is stored when there is an open, short or ECU communication malfunction between the power management control ECU and certification ECU (smart key ECU assembly). DTC No. DTC Detection Condition Trouble A ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK FOR CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Smart Key / Trouble Code ...

Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0141,P102D)
DESCRIPTION Refer to DTC P0136 (See page ). HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is t ...