General Maintenance
GENERAL MAINTENANCE
CAUTION / NOTICE / HINT
The owner can do them or they can have them done at a service center.
These items include those that should be checked on a daily basis, those that in most cases do not require special tools, and those that are considered to be reasonable for the owner to do.
General maintenance items and procedures are as follows:
PROCEDURE
1. GENERAL NOTES
2. TIRES
(a) Check the tire inflation pressure with a gauge. Make adjustments if necessary.
(b) Check the surfaces of the tires for cuts, damage or excessive wear.
3. WHEEL NUTS
(a) Check for nuts that are loose or missing. Tighten them if necessary.
4. TIRE ROTATION
(a) Check the maintenance schedule in the owner's manual supplement.
5. WINDSHIELD WIPER BLADES
(a) Check the blades for wear or cracks whenever they are unable to wipe the windshield clean. Replace them if necessary.
6. FLUID LEAKS
(a) Check under the vehicle for leaking fuel, oil, water and other fluids.
NOTICE:
If you smell fuel or notice any leaks, locate the cause and correct it.
7. DOORS AND ENGINE HOOD
(a) Check that all of the doors operate smoothly, and that all the latches lock securely.
(b) When the primary latch is released, check that the engine hood secondary latch prevents the hood from opening.
Removal
REMOVAL
PROCEDURE
1. REMOVE NO. 1 ENGINE UNDER COVER
2. REMOVE NO. 2 ENGINE UNDER COVER
3. REMOVE WINDSHIELD WIPER MOTOR AND LINK
(a) Remove the windshield wiper motor and link (See page
).
4. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY
5. DRAIN ENGIN ...
Security Horn Circuit
DESCRIPTION
When the theft deterrent system is switched from the armed state to the alarm
sounding state, the main body ECU (driver side junction block assembly) controls
the security horn.
WIRING DIAGRAM
PROCEDURE
1.
PERFORM A ...
Front Blower Motor
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT BLOWER MOTOR SUB-ASSEMBLY
(a) Install the front blower motor sub-assembly with the 3 screws.
(b) Con ...