Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT OUTER MIRROR RH
(a) Check the outer mirror heater operation. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the outer mirror RH. |
|
2. INSPECT OUTER MIRROR LH
(a) Check the outer mirror heater operation. (1) Measure the resistance according the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the outer mirror LH. |
|
Removal
REMOVAL
PROCEDURE
1. REMOVE OUTER MIRROR
(a) Push the lower part of the outer mirror surface and tilt it. Text in Illustration
|
|
(b) Apply protective tape as shown in the illustration.
(c) Using a clip remover, disengage the 2 claws at the upper part of the outer mirror. |
|
(d) Disengage the 2 claws and disconnect the outer mirror as shown in the illustration. |
|
(e) Disconnect the 2 connectors and remove the outer mirror. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL OUTER MIRROR
(a) Connect the 2 connectors.
(b) Engage the 2 claws on the lower part of the outer mirror to the outer rear view mirror assembly as shown in the illustration. |
|
(c) Engage the 2 claws on the upper part of the outer mirror to the outer rear view mirror assembly. |
|
Precaution
PRECAUTION
1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following system after the terminal is reconnected:
System Name
...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
PROCEDURE
1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing (See page
...
Removal
REMOVAL
PROCEDURE
1. REMOVE YAW RATE AND ACCELERATION SENSOR
HINT:
Refer to the instructions for Removal of the yaw rate and acceleration sensor
(See page ).
2. REMOVE REAR NO. 2 AIR DUCT
3. REMOVE REAR NO. 1 AIR DUCT
4. REMOVE FRONT NO. 2 FLOO ...