Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
2. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
3. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
4. REMOVE COURTESY LIGHT ASSEMBLY
5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
6. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY
7. REMOVE OUTER MIRROR CONTROL ECU ASSEMBLY
(a) Disconnect the 2 connectors. |
|
(b) Remove the 2 screws and outer mirror control ECU assembly. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL OUTER MIRROR CONTROL ECU ASSEMBLY
(a) Install the outer mirror control ECU assembly with the 2 screws.
(b) Connect the 2 connectors.
2. INSTALL FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY
3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
4. INSTALL COURTESY LIGHT ASSEMBLY
5. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
6. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
7. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG
Terminals Of Ecu
TERMINALS OF ECU
1. POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
(a) Disconnect the I6 power window regulator master switch assembly connector.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
HINT:
Measure the val ...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL REAR SEAT LEG ASSEMBLY RH
(a) Using a T55 "TORX" socket wrench, install the rear seat leg assembly
RH with the 5 "TORX" bolts.
Torque:
A :
42 N·m {428 kgf·cm, 31 ft·lbf}
B : ...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL REAR BUMPER UPPER RETAINER
(a) Engage the guide.
(b) Install the rear bumper upper retainer with the 2 screws.
2. INSTALL REAR TURN SIGNAL LIGHT BULB
(a) Install th ...