Toyota Venza: Operation Check
OPERATION CHECK
1. CHECK POWER SEAT FUNCTION
(a) Check the basic functions.
.png)
(1) Operate the power seat switches and check to make sure each seat function work:
- Sliding
- Front vertical (Driver side only)
- Lumbar support
- Lifter (Driver side only)
- Reclining
2. CHECK FRONT SEAT WITH ADJUSTER FRAME (SLIDING, FRONT VERTICAL, LIFTER AND RECLINING)
(a) Check the PTC operation inside the power seat motor.
HINT:
The PTC thermistor's resistance increases when the power seat switch is held down even after the power seat has been moved to the maximum in one direction. If the resistance increases beyond a specified level, current is cut to prevent a short circuit.
NOTICE:
- The inspection should be performed with the seat installed in the vehicle.
- Perform the 4 steps below for the full range of motion for each power seat function.
(1) Choose a power seat function. Operate the power seat switch and move the seat as much as possible in one direction. Keep the seat in that position for approximately 60 seconds.
(2) Operate the power seat switch again and continue to try to move the seat in the same direction as in the previous step. Measure the amount of time elapsed before current is automatically cut (the sound of the motor has stopped).
Standard:
4 to 90 seconds
(3) After current has been cut, release the power seat switch and wait for approximately 60 seconds.
(4) Operate the same power seat switch and move the seat in the opposite direction. Check that the motor operates.
3. CHECK LUMBAR SUPPORT MOTOR
(a) Inspect the PTC operation inside the power seat motor.
NOTICE:
The inspection should be performed with the seat installed in the vehicle.
(1) Move the lumbar support to either the foremost or rearmost position by operation the lumbar support switch, and keep it there for approximately 60 seconds.
(2) Try to move the lumbar support beyond the maximum position using the switch. Measure the time needed for shutting off the electrical current after the lumbar support stops moving (motor operation sound will stop, inspection of current shut-off).
Standard:
4 to 90 seconds
(3) Release the lumbar support switch and wait for approximately 60 seconds.
(4) Operate the lumbar support switch to move the lumbar support to the opposite position and check that the motor operates.
System Diagram
SYSTEM DIAGRAM
...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
Front Power Seat Control System
Symptom
Suspected Area
See page
All functions do not operate
P/SEAT fuse
...
Other materials about Toyota Venza:
Removal
REMOVAL
CAUTION / NOTICE / HINT
NOTICE:
When disconnecting the steering intermediate shaft assembly and pinion shaft
of steering gear assembly, be sure to place matchmarks before servicing.
PROCEDURE
1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2. SECUR ...
Front Passenger Side Door ECU Communication Stop (B2322)
DESCRIPTION
This DTC is stored when LIN communication between the power window regulator
motor assembly (for front passenger side) and main body ECU (driver side junction
block assembly) stops for more than 10 seconds.
DTC No.
DTC D ...
Initialization
INITIALIZATION
1. INITIALIZE POWER WINDOW CONTROL SYSTEM (POWER WINDOW REGULATOR MOTOR ASSEMBLY
(ALL DOORS))
CAUTION:
When the power window regulator motor assembly is reinstalled or replaced, the
power window control system must be initialized. Functio ...
0.1561