OPERATION CHECK
1. INSPECT ILLUMINATED ENTRY SYSTEM OPERATION
NOTICE:
Perform this inspection with the customize parameters at the initial setting.
HINT:
The interior light control illuminates the lights below.
(a) The operation and condition of this control are described below.
Operation |
Condition |
---|---|
Fade in and illuminate constantly |
Any door is opened when all doors are closed. |
Illuminate for 15 seconds, and then fade out |
When any of the following conditions is met, the lights illuminate for 15 seconds, and then fade out.
|
Fade out immediately |
When either of the following conditions is met, the lights fade out immediately.
|
Battery saver |
When no changes occur in the condition of the doors for 20 minutes and a key is not inserted in the ignition key cylinder, these lights turn off*1. When no changes occur in the condition of the doors for 20 minutes and a key is not in the detection area, these lights turn off*2. |
2. BATTERY SAVING CONTROL OPERATION
NOTICE:
Perform this inspection with the customize parameters at the initial settings.
HINT:
The lights controlled by battery saving control are as follows:
(a) The operation and conditions of this control are described below.
Operation |
Condition |
---|---|
Battery saving |
When 20 minutes elapse after the ignition switch is turned from ACC or ON to off and the lights that operate remain on, the lights are turned off. HINT: Battery saving control is canceled when any of the following operations is performed before the lights are turned off by battery saving control. After the operation is performed, the lights remain on for another 20 minutes and then the lights are turned off.
|
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. PERFORM SPARK TEST
(a) Check for DTCs (See page ).
NOTICE:
If any DTC is output, perform troubleshooting procedures for that DTC.
(b) Remove the ignition coils and spark plugs (See page
).
(c) Disconnect ...
Headlight Leveling Ecu
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE HEADLIGHT LEVELING ECU ASSEMBLY
(a) Disconnect the connector.
(b) Remove the bolt and headlight leveling ECU assembly ...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the power mirror control
system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...