Toyota Venza manuals

Toyota Venza: Operation Check

OPERATION CHECK

1. CHECK AUTO OPERATION

NOTICE:

Make sure that initialization is completed before inspection (See page ).


HINT:

When pressing the switch for 0.3 seconds or less, the roof glass moves but auto operation does not operate.

(a) Turn the ignition switch to ON.

(b) When the roof glass is fully closed, press the SLIDE OPEN switch for 0.3 seconds or more. Check that the roof glass automatically slides until it is fully opened.

(c) When the roof glass is fully closed, press the TILT UP switch for 0.3 seconds or more. Check that the roof glass automatically tilts up until it is fully tilted upward.

(d) When the auto operation is operating, check that pressing any sliding roof switch stops the roof glass operation.

2. CHECK SLIDING ROOF OPERATION AFTER IGNITION SWITCH IS TURNED OFF

(a) Turn the ignition switch from ON to off, and check that the sliding roof can be operated. Then open the driver or front passenger door once, and check that the sliding roof cannot be operated.

(b) Turn the ignition switch from ON to off and wait for approximately 43 seconds. Check that the sliding roof cannot be operated.

(c) Operate the auto operation (slide open or tilt up) with the driver front passenger door open. While the roof glass is in motion, turn the ignition switch off. Check that the roof glass stops immediately.

3. CHECK JAM PROTECTION FUNCTION

CAUTION:

  • To avoid injury, do not use a part of your body to check the jam protection function.
  • Do not allow anything to become caught in the sliding roof by accident while servicing.
  • Perform the inspection from the inside of the vehicle.

NOTICE:

  • To avoid damaging the roof, do not use hard objects such as a hammer to check the jam protection function.
  • If the jam protection function does not operate, initialize the sliding roof ECU (sliding roof drive gear sub-assembly) (See page ).

(a) When the slide close function is operating and an object is caught between the vehicle body and glass, check that the sliding roof moves in reverse direction.

(b) When the tilt down function is operating, and an object is caught between the vehicle body and the roof glass, check that the sliding roof tilts up fully.

4. CHECK SLIDING ROOF OPEN WARNING

(a) Open the sliding roof by using the sliding roof switch.

(b) When the ignition switch is turned from ON to off and the driver door is opened, check that the warning buzzer in the combination meter assembly sounds once. Then, check that the multi-information display on the accessory meter assembly displays "MOON ROOF OPEN"*.

*: w/ Rear View Monitor

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use these procedure to troubleshoot the sliding roof system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP ...

Initialization
INITIALIZATION 1. INITIALIZE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) NOTICE: When the sliding roof glass, sliding roof housing or sliding roof ECU (sliding roof drive ge ...

Other materials about Toyota Venza:

Air conditioning filter
The air conditioning filter must be changed regularly to maintain air conditioning efficiency.  - Removal method Vehicles with smart key system: Turn the “ENGINE START STOP” switch off. Vehicles without smart key system: Turn the engine switch ...

Idle Control System Malfunction (P0505)
DESCRIPTION The idle speed is controlled by the electronic throttle control system. The electronic throttle control system is comprised of: 1) the one-valve-type throttle body; 2) the throttle actuator, which operates the throttle valve; 3) the throttle p ...

Door Control Switch
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT DOOR CONTROL SWITCH ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Conn ...

© 2016-2024 Copyright www.tovenza.com

0.136