DESCRIPTION
If the steering lock ECU (steering lock actuator assembly) determines that there is a malfunction inside the ECU, it outputs this DTC. Diagnostic communication between the steering lock ECU (steering lock actuator assembly) and the Techstream is performed via the certification ECU as the steering lock ECU (steering lock actuator assembly) is not connected to CAN.
DTC No. |
DTC Detecting Condition |
Trouble Area |
---|---|---|
B2781 |
|
Steering lock ECU (Steering lock actuator assembly) |
CAUTION / NOTICE / HINT
HINT:
After replacing the steering lock ECU (steering lock actuator assembly), confirm the Initialization of the steering lock (See page ).
PROCEDURE
1. |
REPLACE STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY) |
HINT:
The steering lock ECU and steering lock actuator assembly are supplied as a single unit.
(a) Replace the steering lock ECU (steering lock actuator assembly) (See page ).
NEXT |
END |
Installation
INSTALLATION
PROCEDURE
1. INSTALL UNLOCK WARNING SWITCH
(a) Engage the 2 claws and install the unlock warning switch to the steering
column upper bracket.
(b) Extract the key.
(c) Co ...
Glove Box Light
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT GLOVE BOX LIGHT ASSEMBLY
(a) Connect a positive (+) lead from the battery to terminal 1 and a
negative (-) lead to terminal 2.
...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
Use the table below to help determine the cause of problem symptoms. If multiple
suspected areas are listed, the potential causes of the symptoms are listed in order
of probability in the "Suspected Area" column of the tab ...