ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT COOLING FAN OPERATION AT LOW TEMPERATURES (Below 83°C (181°F))
(a) Turn the ignition switch to ON.
(b) Check that the cooling fans stop.
If not, check the cooling fan relays and engine coolant temperature sensor, and check whether there is disconnection or an open circuit between them.
(c) Disconnect the engine coolant temperature sensor connector.
(d) Check that the cooling fans operate.
If not, check the fuses, cooling fan relays, ECM and cooling fans, and check for a short circuit between the cooing fan relays and engine coolant temperature sensor.
(e) Reconnect the engine coolant temperature sensor connector.
2. INSPECT COOLING FAN OPERATION AT HIGH TEMPERATURES (Above 93°C (199°F))
(a) Start the engine, and raise the engine coolant temperature to above 93°C (199°F).
HINT:
Engine coolant temperature is detected by the engine coolant temperature sensor on the water outlet.
(b) Check that the cooling fans operate.
If not, replace the engine coolant temperature sensor.
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL FUEL PUMP ASSEMBLY WITH FILTER
HINT:
Perform "Inspection After Repair" after replacing the fuel pump (See page
).
(a) Apply gasoline to a new O-ring. Then install the O-ring and spacer
to the fuel ...
Washer Motor(for Rear Side)
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL RH
2. REMOVE FRONT FENDER OUTSIDE MOULDING RH
HINT:
Use the same procedure for the RH side and LH side (See page
).
3. REMOVE FRONT FENDER LINER RH
4. DRAI ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Perform "Inspection After Repair" after replacing the camshaft, No. 2 camshaft,
camshaft timing gear assembly or camshaft timing exhaust gear assembly (See page
).
PROCEDURE
1. INSTALL NO. 2 CAMSHAF ...