ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT COOLING FAN MOTOR
(a) Check that the motor operates smoothly when the battery is connected to the cooling fan motor connector. Text in Illustration
If the motor does not operate smoothly, replace the cooling fan motor. |
|
(b) Connect the pickup of a clamp-on ammeter over one of the 2 wires for the cooling fan motor.
(c) Measure the current while the motor is operating.
Standard Current:
Item |
Condition |
Specified Condition |
---|---|---|
Cooling fan motor (w/o Towing package) |
20°C (68°F) |
11.8 to 14.8 A at 12 V |
Cooling fan motor (w/ Towing package) |
20°C (68°F) |
7.9 to 10.9 A at 12 V |
If the result is not as specified, replace the cooling fan motor.
2. INSPECT NO. 2 COOLING FAN MOTOR
(a) Check that the motor operates smoothly when the battery is connected to the No. 2 cooling fan motor connector. Text in Illustration
If the motor does not operate smoothly, replace the No. 2 cooling fan motor. |
|
(b) Connect the pickup of a clamp-on ammeter over one of the 2 wires for the No. 2 cooling fan motor.
(c) Measure the current while the motor is operating.
Standard Current:
Item |
Condition |
Specified Condition |
---|---|---|
No. 2 cooling fan motor (w/o Towing package) |
20°C (68°F) |
7.9 to 10.9 A at 12 V |
No. 2 cooling fan motor (w/ Towing package) |
20°C (68°F) |
7.9 to 10.9 A at 12 V |
If the result is not as specified, replace the No. 2 cooling fan motor.
Open or Short Circuit in ABS Solenoid Relay Circuit (C0278/11)
DESCRIPTION
The ABS solenoid relay supplies power to the ABS solenoid and TRAC solenoid.
The solenoid relay is turned on 1.5 seconds after the ignition switch is turned
to ON, and is turned off if an open or short in the solenoid is detected by self
diag ...
Monitor Drive Pattern
MONITOR DRIVE PATTERN
1. TEST MONITOR DRIVE PATTERN FOR ECT
CAUTION:
Perform this drive pattern on a level surface and strictly observe the posted
speed limits and traffic laws while driving.
HINT:
Performing this drive pattern is one method to simulate ...
Locking the driver’s doors from the outside without a key
Move the inside lock button to the
lock position.
Close the door.
►Vehicles with smart key system
The door cannot be locked if the “ENGINE START STOP” switch is in ACCESSORY or IGNITION
ON mode, or the electronic key is left inside the vehic ...