Toyota Venza manuals

Toyota Venza: On-vehicle Inspection

ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE REAR WHEEL

2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY


3. REMOVE REAR DISC


4. INSPECT REAR AXLE HUB BEARING LOOSENESS

(a) Using a dial indicator, check for looseness near the center of the rear axle hub and bearing assembly.

Maximum looseness:

0.05 mm (0.00196 in.)

NOTICE:

Ensure that the dial indicator is set perpendicular to the measurement surface.

If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.


5. INSPECT REAR AXLE HUB RUNOUT

(a) Using a dial indicator, check for runout on the surface of the rear axle hub and bearing assembly outside the rear axle hub bolt.

Maximum runout:

0.08 mm (0.00314 in.)

NOTICE:

Ensure that the dial indicator is set perpendicular to the measurement surface.

If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.


6. INSTALL REAR DISC


7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY


8. INSTALL REAR WHEEL

Torque:

103 N·m {1050 kgf·cm, 76 ft·lbf}

Components
COMPONENTS ILLUSTRATION ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR AXLE HUB ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL GENERATOR ASSEMBLY (a) Install the generator with the 2 bolts. Torque: 52 N·m {530 kgf·cm, 38 ft·lbf} (b) Install the wire harness clamp bracke ...

Reverse Shift-linked Function of Power Mirrors does not Operate
SYSTEM DESCRIPTION On receiving a reverse signal from the park/neutral position switch assembly, the ECM sends the reverse signal to the main body ECU (driver side junction block assembly) via CAN communication. When receiving the reverse signal, the main ...

Main Body Ecu
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE UPPER INSTRUMENT PANEL HINT: Refer to the procedure up to Remove Upper Instrument Panel Sub-assembly (See page ). 2. REMOVE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEM ...

© 2016-2024 Copyright www.tovenza.com

0.1455