Toyota Venza: On-vehicle Inspection

Toyota Venza Service Manual / Theft Deterrent / Keyless Entry / Smart Key System(for Start Function) / On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. CHECK POWER SOURCE MODE CHANGE FUNCTION

(a) Check the function of the engine switch.

(1) Check that power source mode changes in accordance with the conditions of the shift position and brake pedal.

Brake Pedal	Shift Lever	Power Source Mode Pattern
Depressed	P or N	When the engine switch is pushed once. off → engine start
Not depressed	P	Each time the engine switch is pushed. off → on (ACC) → on (IG) → off
Not depressed	Except P	Each time the engine switch is pushed. off → on (ACC) → on (IG) → on (ACC)
-	P	When the engine switch is pushed in the on (IG) condition (engine running). on (IG) → off
-	Except P	When the engine switch is pushed in the on (IG) condition (engine running). on (IG) → on (ACC)

(b) Check that the power source mode changes without pressing the engine switch.

(1) With power source mode on (ACC) and the shift lever in P, wait for at least 1 hour. Check that the power source mode changes from on (ACC) to off automatically.

2. CHECK INDICATOR CONDITION

(a) Check the indicator light on the engine switch.

(1) Check that the engine switch indicator turns on and changes color according to the table below.

Power Source Mode/Condition	Indicator Light Condition
Power Source Mode/Condition	Brake Pedal Released	Brake Pedal Depressed, Shift Lever in P or N
off	off	Turns on (Green)
on (ACC, IG)	Turns on (Amber)	Turns on (Green)
Engine running	off	off
Steering lock not unlocked	Flashes (Green) for 30 sec.	Flashes (Green) for 30 sec.
System malfunction	Flashes (Amber) for 15 sec.	Flashes (Amber) for 15 sec.

Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is stored during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" bel ...

Detecting Vehicle Submersion (B2277)

DESCRIPTION This DTC is stored when the submersion circuit monitor inside the power management control ECU detects a large amount of water. DTC No. DTC Detection Condition ...

Other materials about Toyota Venza:

Garage Door Opener Switch
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE ROOF CONSOLE BOX ASSEMBLY (GARAGE DOOR OPENER SWITCH) (a) Using a moulding remover, disengage the 2 claws and 2 clips. Text in Illustration *1 ...

Terminals Of Ecu
TERMINALS OF ECU 1. STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY) Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition D17-1 (GND) - Body ground ...

Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT POWER SEAT SWITCH LH (w/o Seat Position Memory System) (a) Measure the resistance between the terminals when each switch is operated. Standard Resistance: Slide Switch Tester Co ...