ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to follow the correct removal and installation procedures of the steering pad.
PROCEDURE
1. INSPECT STEERING PAD (Vehicle not Involved in Collision)
(a) Perform a diagnostic system check (See page ).
(b) Visually check for defects with the steering pad installed on the vehicle.
HINT:
The defects are as follows:
OK:
No defects are found.
If any defects are found, replace the steering pad with a new one.
2. INSPECT STEERING PAD (Vehicle Involved in Collision and Airbag has not Deployed)
(a) Perform a diagnostic system check (See page ).
(b) Visually check for defects with the steering pad removed from the vehicle.
HINT:
The defects are as follows:
OK:
No defects are found.
If any defects are found, replace the steering pad or steering wheel assembly with a new one.
Vehicle Speed Signal Malfunction (C1541)
DESCRIPTION
The power steering ECU receives vehicle speed signals from the brake actuator
assembly (skid control ECU) via CAN communication. The ECU provides appropriate
assisting force in accordance with the vehicle speed, based on the signals.
...
Removal
REMOVAL
PROCEDURE
1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for 2WD)
When Not Using the Engine Support Bridge: (See page
)
When Using the Engine Support Bridge: (See page
)
2. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for AWD)
When Not Using the Engine Supp ...
Relay
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT IG2 RELAY
(a) Remove the IG2 relay from the relay block.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Te ...