Toyota Venza manuals

Toyota Venza: On-vehicle Inspection

ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

CAUTION:

Be sure to follow the correct removal and installation procedures of the front seat side airbag assembly.

PROCEDURE

1. INSPECT FRONT SEAT SIDE AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)

(a) Perform a diagnostic system check (See page ).


(b) Visually check for defects with the front seat side airbag assembly installed on the vehicle.

(1) The defects are as follows:

  • Cuts on the front seatback assembly around the front seat side airbag assembly
  • Small cracks on the front seatback assembly around the front seat side airbag assembly
  • Significant discoloration on the front seatback assembly around the front seat side airbag assembly

OK:

No defects are found.

HINT:

If any of the defects is found, replace the separate type front seatback pad or separate type front seatback cover with a new one.


2. INSPECT FRONT SEAT SIDE AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

(a) Perform a diagnostic system check (See page ).


(b) Visually check for defects with the front seat side airbag assembly removed from the vehicle.

(1) The defects are as follows:

  • Scratches on the surface of the front seat side airbag assembly base fabric
  • Broken or frayed threads on the surface of the front seat side airbag assembly base fabric
  • Marks from being dropped
  • Deformation on the installation part of the front seat side airbag assembly
  • Cracks or other damage to the wire harness or connector

OK:

No defects are found.

HINT:

If any of the defects is found, replace the front seat side airbag assembly with a new one.


Components
COMPONENTS ILLUSTRATION ...

Removal
REMOVAL PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing (See page ). If the front seat side airbag assembly was deployed, replace the front ...

Other materials about Toyota Venza:

System Diagram
SYSTEM DIAGRAM 1. MIRROR CONTROL SYSTEM Communication Table Sender Receiver Signal / Signal Condition Line Main body ECU (driver side junction block assembly) Outer mirror control EC ...

System Too Lean (Bank 1) (P0171,P0172)
DESCRIPTION The fuel trim is related to the feedback compensation value, not to the basic injection duration. The fuel trim consists of both the short-term and long-term fuel trims. The short-term fuel trim is fuel compensation that is used to constantly ...

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION The ECM controls the cruise control system of the vehicle. The data and DTCs relating to the cruise control system can be read from the DLC3 of the vehicle. If either DTC or CRUISE OK is not displayed on the multi-informat ...

© 2016-2024 Copyright www.tovenza.com

0.1355