Toyota Venza: On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to correctly follow the removal and installation procedures for the front passenger airbag assembly.
PROCEDURE
1. INSPECT FRONT PASSENGER AIRBAG ASSEMBLY (Vehicle not Involved in Collision)
(a) Perform a diagnostic system check (See page
.gif)
).
(b) Visually check for defects with the front passenger airbag assembly installed on the vehicle.
HINT:
The defects are as follows:
- Cuts on the instrument panel safety pad assembly around the front passenger airbag assembly
- Small cracks on the instrument panel safety pad assembly around the front passenger airbag assembly
- Significant discoloration on the instrument panel safety pad assembly around the front passenger airbag assembly
OK:
No defects are found.
If any defects are found, replace the instrument panel safety pad sub-assembly with a new one.
2. INSPECT FRONT PASSENGER AIRBAG ASSEMBLY (Vehicle Involved in Collision and Airbag has not Deployed)
(a) Perform a diagnostic system check (See page
).
(b) Visually check for defects with the front passenger airbag assembly removed from the vehicle.
HINT:
- Cuts
- Small cracks
- Significant discoloration
- Cracks or other damage to the connector
- Deformation or cracks on the instrument panel safety pad assembly or instrument panel reinforcement
OK:
No defects are found.
If any defects are found, replace the front passenger airbag assembly, instrument panel safety pad sub-assembly or instrument panel reinforcement with a new one.
Components
COMPONENTS
ILLUSTRATION
...
Removal
REMOVAL
PROCEDURE
1. PRECAUTION
NOTICE:
Be sure to read Precaution thoroughly before servicing (See page
).
2. REMOVE SHIFT LEVER ASSEMBLY
(See page )
3. DISCONNECT INSTRUMENT PANEL WIRE ASS ...
Other materials about Toyota Venza:
Center Airbag Sensor Assembly Communication Circuit Malfunction (B1790)
DESCRIPTION
The center airbag sensor assembly communication circuit consists of the occupant
classification ECU and center airbag sensor assembly.
DTC B1790 is recorded when a malfunction is detected in the center airbag sensor
assembly communication cir ...
Adjustment
ADJUSTMENT
CAUTION / NOTICE / HINT
HINT:
Centering bolts are used to mount the hood hinge and hood lock. The
hood and hood lock cannot be adjusted with the centering bolts installed.
Substitute the centering bolts with standard bolts when ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
When disconnecting the steering intermediate shaft assembly and pinion shaft
of steering gear assembly, be sure to place matchmarks before servicing.
PROCEDURE
1. INSTALL TIE ROD ASSEMBLY LH
(a) I ...
0.1337