ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT DRIVER SIDE SEAT BELT WARNING
(a) Turn the ignition switch to ON.
(b) When the driver side seat belt is not fastened, check that the driver side seat belt warning light on the combination meter assembly blinks.
(c) When the driver side seat belt is fastened, check that the driver side seat belt warning light on the combination meter assembly is off.
2. INSPECT FRONT PASSENGER SIDE SEAT BELT WARNING
(a) Turn the ignition switch to ON.
(b) When the front passenger side seat belt is not fastened with the front passenger side seat occupied, check that the front passenger side seat belt warning light on the accessory meter assembly blinks.
(c) When the front passenger side seat belt is fastened with the front passenger side seat occupied, check that the front passenger side seat belt warning light on the accessory meter assembly is off.
3. INSPECT SEAT BELT WARNING BUZZER
HINT:
The seat belt warning buzzer can be customized. Make sure that this function is ON.
(a) Turn the ignition switch to ON.
(b) When the vehicle is driven at approximately 20 km/h (13 mph) or more while the driver or front passenger side seat belt is not being fastened, check that the buzzer in the combination meter assembly sounds at an interval of 1.2 seconds for 9.6 seconds.
(c) After previous step, check that the buzzer sounds at an interval of 0.4 seconds for 20 seconds.
(d) After the buzzer has stopped, turn the ignition switch off and then start the engine again. Drive the vehicle at approximately 20 km/h (13 mph) or more while the driver or front passenger side seat belt is not being fastened, and then check that the buzzer sounds again.
(e) After the buzzer has stopped, fasten the driver and front passenger seat belts. Drive the vehicle at approximately 20 km/h (13 mph) or more and unfasten the driver or front passenger side seat belt, and then check that the buzzer sounds again.
(f) After the buzzer has stopped, move the shift lever to R, and then move it to D. Drive the vehicle at approximately 20 km/h (13 mph) or more, and then check that the buzzer sounds again.
Motor Circuit Malfunction (C1521,C1531-C1534,C1554)
DESCRIPTION
If the power steering ECU detects these DTCs, it will shut off the motor relay
circuit (built into the power steering ECU) and stop power assist. However, power
assist continues if DTC C1533 or C1534 is stored.
DTC No.
D ...
Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Perform "Inspection After Repair" after replacing the cylinder head sub-assembly
(See page ).
PROCEDURE
1. INSTALL SPARK PLUG TUBE
HINT:
When using a new cylinder head, the spark plug tubes must be r ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)
(a) Install the vacuum switching valve assembly (for ACIS) with the bolt.
Torque:
9.0 N·m {92 kgf·cm, 80 in·lbf}
...