ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT COOLER CONDENSER ASSEMBLY
(a) If the cooler condenser assembly fins are dirty, clean them with water and dry with compressed air.
NOTICE:
Do not damage the cooler condenser assembly fins.
(b) If any cooler condenser assembly fins are bent, straighten them using a screwdriver or pliers.
2. INSPECT FOR REFRIGERANT LEAK
(a) Using a halogen leak detector, check pipe joints for refrigerant leaks.
(b) If refrigerant leak is detected in a joint, check the torque of the joint.
Noise Occurs
PROCEDURE
1.
NOISE CONDITION
(a) Check from which direction the noise comes (front left or right, or rear
left or right).
OK:
The location of the noise source can be determined.
NG
GO TO STEP 3
...
Afs Ecu
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL AFS ECU
(a) Engage the guide.
(b) Install the AFS ECU with the bolt.
(c) Connect the connector.
2. INSTA ...
Stop Light Control Relay Malfunction (C1380/64)
DESCRIPTION
Upon receiving the hill-start assist control operating signal from the skid control
ECU, the relay contact turns on and the stop light comes on.
DTC Code
DTC Detection Condition
Trouble Area
C13 ...