ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY
(a) for RH Side
(1) Operate the windshield wiper motor assembly. |
|
(2) Stop the windshield wiper motor assembly operation.
(3) Check the automatic stop (park) position.
OK:
The front wiper stops at the position shown in the illustration.
(b) for LH Side
(1) Operate the windshield wiper motor assembly. |
|
(2) Stop the windshield wiper motor assembly operation.
(3) Check the automatic stop (park) position.
OK:
The front wiper stops at the position shown in the illustration.
Text in Illustration
*1 |
Ceramic Notch |
Throttle / Pedal Position Sensor "A" Minimum Stop Performance (P2109)
DESCRIPTION
The idle speed is controlled by the Electronic Throttle Control System (ETCS).
The ETCS is comprised of a throttle actuator, which operates the throttle valve,
and a throttle position sensor, which detects the opening amount of the throttle
...
Removal
REMOVAL
PROCEDURE
1. DISCHARGE FUEL SYSTEM PRESSURE
HINT:
See page
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page ).
3. REMOVE W ...
Rear Wiper Rubber
Components
COMPONENTS
ILLUSTRATION
Replacement
REPLACEMENT
PROCEDURE
1. REMOVE REAR WIPER BLADE
(a) Disconnect the rear wiper arm head cap.
(b) Raise the wiper blade to the posi ...