Toyota Venza: On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT HOOD SUB-ASSEMBLY
(a) Check that the clearance measurements of areas *1 through *4 are within each standard range.
Standard Clearance
|
Area |
Measurement |
Area |
Measurement |
|---|---|---|---|
|
*1 |
6.9 to 9.9 mm (0.272 to 0.390 in.) |
*3 |
2.8 to 5.8 mm (0.110 to 0.228 in.) |
|
*2 |
7.6 to 10.6 mm (0.299 to 0.417 in.) |
*4 |
-1.5 to 1.5 mm (-0.0591 to 0.0591 in.) |
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE HOOD TO RADIATOR SUPPORT SEAL
(a) Using a clip remover, disengage the 10 clips and remove the hood
to radiator support seal.
...
Adjustment
ADJUSTMENT
CAUTION / NOTICE / HINT
HINT:
Centering bolts are used to mount the hood hinge and hood lock. The
hood and hood lock cannot be adjusted with the centering bolts installed. ...
Other materials about Toyota Venza:
Terminals Of Ecu
TERMINALS OF ECU
1. CENTER AIRBAG SENSOR ASSEMBLY
Terminal No.
Terminal Symbol
Destination
L31-1
SFL+
Front seat side airbag assembly LH (Side squib LH)
L31-2
...
Transmission Control Switch Circuit
DESCRIPTION
When the shift lever is in S and it is moved toward "-" or "+", it is possible
to select different shift ranges (1st through 6th ranges).
Moving the shift lever toward "+" increases the shift range by one, and movi ...
Back door
The back door can be opened using the back door opener. The back door can
be locked and unlocked using the entry function (vehicles with smart key system),
wireless remote control or door lock switch.
In addition, the power back door (if equipped) can be ...
0.1481