Toyota Venza manuals

Toyota Venza: Off-road driving

Your vehicle is not designed to be driven off-road. However, in the event that off-road driving cannot be avoided, please observe the following precautions to help avoid the areas prohibited to vehicles.

• Drive your vehicle only in areas where off-road vehicles are permitted to travel.

• Respect private property. Get owner’s permission before entering private property.

• Do not enter areas that are closed. Honor gates, barriers and signs that restrict travel.

• Stay on established roads. When conditions are wet, driving techniques should be changed or travel delayed to prevent damage to roads.

 - Additional information for off-road driving

For owners in U.S. mainland, Hawaii and Puerto Rico:

To obtain additional information pertaining to driving your vehicle off-road, consult the following organizations.

• State and Local Parks and Recreation Departments • State Motor Vehicle Bureau • Recreational Vehicle Clubs • U.S. Forest Service and Bureau of Land Management

CAUTION

 - Off-road driving precautions

Always observe the following precautions to help minimize the risk of serious personal injury or damage to your vehicle:

• Drive carefully when off the road. Do not take unnecessary risks by driving in dangerous places.

• Do not grip the steering wheel spokes when driving off-road. A bad bump could jerk the wheel and injure your hands. Keep both hands and especially your thumbs on the outside of the rim.

• Always check your brakes for effectiveness immediately after driving in sand, mud, water or snow.

• After driving through tall grass, mud, rock, sand, rivers, etc., check that there is no grass, bush, paper, rags, stone, sand, etc. adhering or trapped on the underbody. Clear off any such matter from the underbody. If the vehicle is used with these materials trapped or adhering to the underbody, a breakdown or fire could occur.

• When driving off-road or in rugged terrain, do not drive at excessive speeds, jump, make sharp turns, strike objects, etc. This may cause loss of control or vehicle rollover causing death or serious injury. You are also risking expensive damage to your vehicle’s suspension and chassis.

NOTICE
 - To prevent the water damage

Take all necessary safety measures to ensure that water damage to the engine or other components does not occur.

• Water entering the engine air intake will cause severe engine damage.

• Water entering the automatic transmission will cause deterioration in shift quality, locking up of your transmission accompanied by vibration, and ultimately damage.

• Water can wash the grease from wheel bearings, causing rusting and premature failure, and may also enter the differentials, transmission and transfer case, reducing the gear oil’s lubricating qualities.

- When you drive through water

If driving through water, such as when crossing shallow streams, first check the depth of the water and the bottom of the river bed for firmness. Drive slowly and avoid deep water.

- Inspection after off-road driving

• Sand and mud that has accumulated in brake drums and around brake discs may affect braking efficiency and may damage brake system components.

• Always perform a maintenance inspection after each day of off-road driving that has taken you through rough terrain, sand, mud, or water. For scheduled maintenance information, refer to the “Scheduled Maintenance Guide” or “Owner’s Manual Supplement”.

Utility vehicle feature
• Specific design characteristics give it a higher center of gravity than ordinary passenger cars. This vehicle design feature causes this type of vehicle to be more likely to rollover. And, uti ...

Cargo and luggage
Take notice of the following information about storage precautions, cargo capacity and load. • Stow cargo and luggage in the luggage compartment whenever possible. Be sure all items are secure ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. REMOVE FRONT DOOR SCUFF PLATE LH 2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH 3. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL 4. REMOVE OUTER MIRROR SWITCH ASSEMBLY (a) Disengage the 2 claws and remove the outer m ...

Window Glass Antenna Wire
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT WINDOW GLASS ANTENNA WIRE (a) Check for continuity of the antenna. HINT: Check for continuity at the center of each antenna wire as shown in the illustration. N ...

Terminals Of Ecu
TERMINALS OF ECU 1. CLEARANCE WARNING ECU ASSEMBLY (a) Disconnect the D79 clearance warning ECU assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. Terminal No. (Symbol) Wiring ...

© 2016-2024 Copyright www.tovenza.com

0.1715