PROCEDURE
1. |
CHECK LOOSENESS OF V-RIBBED BELT |
(a) Check the tension of the belt by pushing it down with a finger.
OK:
The tension of the belt is enough.
NG |
ADJUST V-RIBBED BELT |
|
2. |
CHECK V-RIBBED BELT FOR WEAR |
(a) Check the V-ribbed belt for wear.
OK:
The V-ribbed belt is not worn.
NG |
REPLACE V-RIBBED BELT |
|
3. |
CHECK GENERATOR CLUTCH PULLEY FOR WEAR |
(a) Check the clutch pulley grooves for wear or other defects.
OK:
The clutch pulley grooves are not damaged.
NG |
REPLACE GENERATOR CLUTCH PULLEY |
|
4. |
CHECK FOR NOISE WHILE GENERATOR CLUTCH PULLEY IS OPERATING |
(a) Perform a road test and check if noise occurs when decelerating.
OK:
Noise does not occur.
OK |
REPLACE GENERATOR ASSEMBLY |
NG |
REPLACE GENERATOR CLUTCH PULLEY |
Front Occupant Classification Sensor RH Circuit Malfunction (B1781)
DESCRIPTION
The front occupant classification sensor RH circuit consists of the occupant
classification ECU and front occupant classification sensor RH.
DTC B1781 is recorded when a malfunction is detected in the front occupant classification
sensor RH c ...
Front Fog Light Circuit
DESCRIPTION
The main body ECU (driver side junction block assembly) controls the fog light
relay.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following
inspection procedu ...
Center Airbag Sensor Assembly Communication Circuit Malfunction (B1790)
DESCRIPTION
The center airbag sensor assembly communication circuit consists of the occupant
classification ECU and center airbag sensor assembly.
DTC B1790 is recorded when a malfunction is detected in the center airbag sensor
assembly communication cir ...