PROCEDURE
1. |
CHECK NOISE CONDITION |
(a) Check from which direction the noise comes (front left or right, or rear left or right).
OK:
The location of the noise source can be determined.
NG |
GO TO STEP 3 |
|
2. |
CHECK SPEAKERS |
(a) Check the installation condition of the speaker units that are located near the noise source and that there are no cracks, scratches, deformation or other failures.
Result |
Proceed to |
---|---|
No malfunction is found. |
A |
A speaker is installed incorrectly. |
B |
Foreign matter is in a speaker. |
C |
A speaker cone paper is broken. |
D |
B |
REINSTALL SPEAKER |
C |
REMOVE FOREIGN MATTER |
D |
REPLACE SPEAKER |
|
3. |
CHECK NOISE CONDITIONS |
(a) Check the noise condition.
HINT:
The radio has a noise prevention function to reduce noise when listening to the radio. If a loud noise occurs, check whether the ground at the antenna mounting base and the noise prevention unit are installed and wired correctly.
Condition under which Noise Occurs |
Noise Source |
---|---|
Noise increases when the accelerator pedal is depressed, but stops when the engine is stopped. |
Generator |
Noise occurs during A/C or heater operation. |
Blower motor |
Noise occurs when the horn switch is pressed and released or when pressed and held. |
Horn |
Noise occurs synchronously with the turn signal blinking pattern. |
Flasher |
Noise occurs during window washer operation. |
Washer |
Noise occurs during wiper operation. |
Wiper |
Noise occurs when the brake pedal is depressed. |
Stop light switch |
Others |
Static electricity |
HINT:
Result |
Proceed to |
---|---|
The noise source cannot be determined. |
A |
The noise source can be determined. |
B |
A |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
B |
REPAIR OR REPLACE NOISE SOURCE |
No Response from Steering Lock ECU (B2786)
DESCRIPTION
This DTC is stored when LIN communication between the certification ECU (smart
key ECU assembly) and steering lock ECU (steering lock actuator assembly) stops
for more than 10 seconds.
DTC No.
DTC Detection Condition
...
Rear Right Sensor Malfunction (C1AE9)
DESCRIPTION
The No. 1 ultrasonic sensor (rear right sensor) is installed on the rear bumper.
The ECU detects obstacles based on signals received from the No. 1 ultrasonic sensor
(rear right sensor). If the No. 1 ultrasonic sensor (rear right sensor) has a ...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
2.
CUSTOMER PROBLEM ANALYSIS
...