Toyota Venza: No Sound can be Heard from Speakers

Toyota Venza Service Manual / Navigation / Multi Info Display / Navigation System / No Sound can be Heard from Speakers

PROCEDURE

1.	CHECK AUDIO SETTINGS

(a) In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal.

OK:

Audio system returns to normal.

HINT:

Sound quality adjustment measures vary according to the type of amplifier.

END

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Traffic Information is not Displayed

PROCEDURE 1. CHECK DISPLAY (a) Check which communication is not being used for displaying traffic information. HINT: Display of traffic information received via HD ...

Sound Quality is Bad Only when CD is Played (Volume is Too Low)

PROCEDURE 1. REPLACE CD AND RECHECK (a) Replace the CD with a new or known good one and check that the malfunction disappears. OK: Malfunction disappears. ...

Other materials about Toyota Venza:

Diagnosis System
DIAGNOSIS SYSTEM 1. CHECK DLC3 (a) Check the DLC3 (See page ). 2. FUNCTION OF P/S WARNING LIGHT (a) When a malfunction is detected in the power steering system, the P/S warning light on the accessory meter comes on to inform the driver of the malfunctio ...

Removal
REMOVAL PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing (See page ). If the front seat side airbag assembly was deployed, replace the front seat side airbag assembly, front seat frame assembly wit ...

Installation
INSTALLATION PROCEDURE 1. ADJUST COMPRESSOR OIL LEVEL (a) When replacing the cooler compressor assembly with a new one, gradually discharge the inert gas (helium) from the service valve, and drain the following amount of oil from the vent ...