PROCEDURE
1. |
CHECK AUDIO SETTINGS |
(a) In sound setting mode, set volume, fader and balance to the initial values and check that the sound is normal.
OK:
Audio system returns to normal.
HINT:
Sound quality adjustment measures vary according to the type of amplifier.
OK |
END |
NG |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Short in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL)
(P2769,P2770)
DESCRIPTION
Shift solenoid valve SL is turned on and off by signals from the TCM to control
the hydraulic pressure acting on the lock-up relay valve, which then controls operation
of the lock-up clutch.
DTC No.
DTC Detection Conditi ...
Antenna Coil Open / Short (B2784)
DESCRIPTION
The transponder key coil is built into the transponder key amplifier and receives
a key code signal from the transponder chip in the key. This signal is amplified
by the amplifier, then it is output to the transponder key ECU assembly.
...
Removal
REMOVAL
PROCEDURE
1. REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE
(a) Remove the fuel suction tube assembly with pump and gauge (See page
).
2. REMOVE FUEL SENDER GAUGE
3. REMOVE FUEL FILTER ASSEMBLY
(a) Disconnect the fuel pump ...