Toyota Venza: Mirror (ext)
- Outer Mirror Control Ecu
- Outer Mirror Switch
- Outer Rear View Mirror
- Outer Rear View Mirror Cover
- Outer Rear View Mirror Glass
- Power Mirror Control System(w/ Memory)
- Precaution
- Parts Location
- System Description
- System Diagram
- How To Proceed With Troubleshooting
- Operation Check
- Problem Symptoms Table
- Terminals Of Ecu
- Data List / Active Test
- Diagnosis System
- Driver Side Power Mirror cannot be Adjusted with Power Mirror Switch
- Front Passenger Side Power Mirror cannot be Adjusted with Power Mirror Switch
- Power Mirror cannot be Adjusted with Power Mirror Switch
- Power Mirror Surface Position is not Memorized
- Power Mirrors do not Return to Memorized Position
- Reverse Shift-linked Function of Power Mirrors does not Operate
- Wireless Transmitter Memory Function does not Operate
- Wireless-linked Return Function does not Operate
- Power Mirror Control System(w/o Memory)
Turn Signal Flasher Assembly
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT TURN SIGNAL FLASHER ASSEMBLY
(a) Disconnect the D34 turn signal flasher assembly connector.
...
Outer Mirror Control Ecu
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
2. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMRE ...
Other materials about Toyota Venza:
Installation
INSTALLATION
PROCEDURE
1. INSTALL INNER REAR VIEW MIRROR ASSEMBLY (w/o Automatic High Beam System)
(a) Using a T20 "TORX" socket wrench, install the inner rear view mirror assembly
with the screw.
Torque:
1.5 N·m {15 kgf·cm, 13 in·lbf}
(b ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL REAR AXLE CARRIER SUB-ASSEMBLY
(a) Temporarily install the rea ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR WIPER MOTOR AND BRACKET ASSEMBLY
(a) Check the wiper low operation.
(1) Connect a battery positive (+) lead to terminal 4 (+B), and a negative (-)
lead to terminal 3 (LS) and terminal 5 (E), and check that the motor ...
0.1411