Toyota Venza: Mf1a Transfer / 4wd / Awd
- 4wd Control Ecu
- Active Torque Control 4wd System
- Precaution
- Parts Location
- System Description
- System Diagram
- How To Proceed With Troubleshooting
- Problem Symptoms Table
- Test Mode Procedure
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Fail-safe Chart
- Diagnostic Trouble Code Chart
- Low Power Supply Voltage (C1241/94)
- Control Module Communication Bus OFF (U0073/86,U0100/85,U0129/83)
- Malfunction in Deceleration Sensor (C1245/93)
- Cancellation of 4WD Control (C1299/99)
- ABS Malfunction (C1296/96)
- Linear Solenoid Circuit (C1298/98)
- Engine Circuit Malfunction (C1280/82)
- AWD Warning Light does not Come ON
- AWD Warning Light Remains ON
- TC and CG Terminal Circuit
- Transfer Assembly(when Not Using The Engine Support Bridge)
- Transfer Assembly(when Using The Engine Support Bridge)
- Transfer Case Front Oil Seal(when Not Using The Engine Support Bridge)
- Transfer Case Front Oil Seal(when Using The Engine Support Bridge)
- Transfer Case Front Oil Seal(for Rh Side)
- Transfer Case Rear Oil Seal
- Transfer Oil
- Transfer System
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR DRIVE SHAFT ASSEMBLY
(a) Align the shaft splines and install the rear drive shaft assembly
using a screwdriver and hammer.
NOTICE:
...
4wd Control Ecu
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT DOOR SCUFF PLATE RH
2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
3. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB ...
Other materials about Toyota Venza:
System Description
SYSTEM DESCRIPTION
1. DESCRIPTION
(a) The steering lock system locks/unlocks the steering when by activating the
steering lock bar with a motor. The steering lock ECU (steering lock actuator assembly)
activates the motor based on signals from the certifi ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT HOOD SUB-ASSEMBLY
(a) Check that the clearance measurements of areas *1 through *4 are within each
standard range.
Standard Clearance
Area
Measurement
Area
Measureme ...
Diagnosis System
DIAGNOSIS SYSTEM
1. DESCRIPTION
(a) The certification ECU (smart key ECU assembly) control the vehicle smart
key system functions. Smart key system data and Diagnostic Trouble Codes (DTCs)
can be read through the vehicle Data Link Connector 3 (DLC3). In ...
0.1771